Where can I get a Toyota 22R carburetor rebuild kit?
Toyota 22R Carburetor. (Disassembly) Before starting the disassembly process I should note that I purchased my rebuild kit from NAPA. Each part/component is labeled numerically from 1-90 and you can essentially look at these numbers as steps to follow during disassembly.
Which is the best carb for a Weber 22R?
The Weber 32/36 is the optimum carburetor to replace a worn out or hard to maintain factory carb. The 32/36 progressive is an excellent carb for low-end power and fuel economy. If you’ve got a mildly built motor or daily driver, the 32/36 is the way to go for torque, low-end power, and fuel economy.
Which is the best carburetor to replace a worn out factory carb?
The Weber 32/36 is the optimum carburetor to replace a worn-out or hard to maintain factory carb. The 32/36 progressive is an excellent carb for low-end power and fuel economy. If you’ve got a mildly built motor or daily driver, the 32/36 is the way to go for torque, low-end power, and fuel economy.
Is the 32 / 36 progressive a good carb?
The 32/36 progressive is an excellent carb for low-end power and fuel economy. If you’ve got a mildly built motor or daily driver, the 32/36 is the way to go for torque, low-end power, and fuel economy. NOTE: Requires 2.5 – 3 lbs of fuel pressure, see regulator kit Part #: 1035056.
What should I remove from my 22r-lc engine?
Below are items that you can start to tear into first (going counter clockwise), from the top left circle:: EGR Vacuum Module and Outer Vent Control Valve. The pesky hard vacuum lines (remove all the vacuum lines attached to it too). Air injection piping (on the exhaust side of the head attached to the headers).
How big of vacuum hose do I need for a 22r-lc engine?
Make sure that you have the Fuel “IN” and Fuel “RETURN” lines hooked up properly at the other side of the hard fuel lines under the manifold and at the tank. You will only need about 6 ft of 1/4″ fuel hose to do the job. You now only need two (2) vacuum lines and will use about 6ft of 5/32″ vacuum hose.
Where are the fuel lines on a 22r-lc?
Run the Fuel “IN”, Fuel “RETURN” and Fuel “FEED” lines as shown below. Make sure that you have the Fuel “IN” and Fuel “RETURN” lines hooked up properly at the other side of the hard fuel lines under the manifold and at the tank.