How do I program my 2004 Remote?
PRESS and HOLD the LOCK button and hold for 2 seconds. RELEASE. The vehicle will respond by cycling the locks from LOCK to UNLOCK to indicate successful programming of the remote. REPEAT Step 7 for any additional remotes to be programmed, including working ones.
Can you reprogram an old key fob?
You could reprogram a key fob to a different vehicle as long as the key is the same for the vehicle. Remove the battery cables from the vehicle, wait 30 seconds, then hook them back up (reset computer). Put the key in the ignition and turn the key to the ‘ON’ position.
How do you program a key fob for a 2004 Chevy 1500?
2004 Chevrolet Silverado 1500 Remote Programming
- Close all doors on the vehicle.
- Then insert key into the ignition.
- Press and hold the power UNLOCK button on driver’s side door panel.
- Quickly turn the ignition ON, OFF, ON, OFF. (
- Release the power unlock button on the driver’s side door panel.
How do you program a key fob for a 2004 Chevy Impala?
PRESS the DISP button to ENTER Programming Mode. WHEN the message “PUSH FOB” is displayed, PRESS and HOLD the LOCK and UNLOCK buttons at the same time on the first remote to be programmed for 15 seconds. The vehicle will sound to indicate successful programming of the remote.
What to do when your car key fob is not working?
Once the above steps are performed, turn the ignition back to the ‘Off’ position to terminate the programming procedure. Take your key fobs with you and leave the vehicle and close all doors. Test to both unlocks with all your key fobs that got programmed to verify the function.
Can a GM FOB be used in programming mode?
The fob functions just fine but the plastic ring that attaches it to my keyring broke so I bought a replacement GM fob from Ebay. The fob came with the standard programming instructions (hold door unlock, cycle the key 2x etc) but I can’t get the truck into programming mode.
Is it possible to take used key fob and reprogram it?
Take the key out of the door and with the door shut, try to unlock the doors with the remote. If the doors will lock then put the key in the ignition switch and try to start the engine. If the engine starts up after these steps, then the key fob is successfully reprogrammed to your vehicle.
Why is my Remote key fob not programming?
There is a footnote on Step #4 that states if the locks cycle before you release the unlock button the programming will not work because you are not in the programming mode. It suggests that you repeat steps 1-4, and if this doesn’t work you probably have a problem with the vehicles keyless entry system.