What to do if power window is not working on Toyota Tundra?
The switchboard behind the door cards controls communication between window motor and switch along with the wiring to the kick panel. Use flat tip screwdriver to lift and disconnect the window switch. Use Allen wrench or screwdriver to remove door card. Remove door pin by unscrewing clockwise.
How do you get the window down on a Toyota?
The only way to get the window down more than 1cm is to go down 1cm till it stops, then hit the auto-up button where it goes to the top, then will go down about 5″. That is the only way to get the window down at all, which unfortunately isnt enough to get my arm through to get parking passes in a garage or use the ATM etc…
How do you open the driver’s door window?
Push down and hold the driver’s door power window switch to completely open the window. 2. Pull and hold up the driver’s door power window switch until the window closes. Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination. 3.
What to do if your car’s automatic window broke?
1. Push down and hold the driver’s door power window switch to completely open the window. 2. Pull and hold up the driver’s door power window switch until the window closes. Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination.
What to do if your power window is not working?
Use flat tip screwdriver to lift and disconnect the window switch. Use Allen wrench or screwdriver to remove door card. Remove door pin by unscrewing clockwise. Test continuity at switchboard. Figure 4.
What to do if front passenger window does not work?
Let’s assume the front passenger window doesn’t work from the passenger switch. Pop out the passenger window switch and disconnect the electrical connector. Using a digital multimeter , connect one lead to ground.
What causes a car window to go up but not down?
If you do, then the motor is bad. If you don’t then check for an open in the wiring or a bad switch. If you’ve tested the passenger switch and don’t the results I’ve shown, you could have a broken wire in the hinge area of the door. These wires flex every time you open and close the door and they do break.