What is the p1381 code on a Honda Accord?
If not, replace the distributor housing, if it is ok check for continuity to ground between each terminal ( same ones ) and body ground. If there is continuity replace the distributor . Here is a picture of the coil shield location. The P1381 code is Cylinder Position Sensor Intermittent Interruption.
Where to reset the ECU on a Honda Accord?
If any of these problems are affecting your Civic or Accord, it is very simple to reset the ECU. Keep reading and this how to will guide you through the process. Open the hood and look for the fuse box, which is located near the passenger’s side. The cover contains a diagram of the fuses, which tells you what each fuse is used for and the amperage.
What should cylinder resistance be on Honda Accord?
If the code comes back, you need to check the cylinder position sensor at distributor, unplug the 4 wire connector at distributor, ( key off ) if you look at the connector with the nipple up, you need to check resistance ( using an ohmmeter ) between the 2 terminals farthest to the right it should be between 800-1500 ohms.
How much does it cost to repair a p1381 Honda engine?
Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P1381 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
If not, replace the distributor housing, if it is ok check for continuity to ground between each terminal ( same ones ) and body ground. If there is continuity replace the distributor . Here is a picture of the coil shield location. The P1381 code is Cylinder Position Sensor Intermittent Interruption.
How to reset my Honda Accord after changing an alarm?
Turn the key to the unlock position. Turn the key to the lock position. Turn the key back to the unlock position. The alarm should now be disabled. Start your Honda Accord’s engine and allow the vehicle to run for at least 10 minutes. This will allow the Accord to reset the alarm.
If the code comes back, you need to check the cylinder position sensor at distributor, unplug the 4 wire connector at distributor, ( key off ) if you look at the connector with the nipple up, you need to check resistance ( using an ohmmeter ) between the 2 terminals farthest to the right it should be between 800-1500 ohms.
How do you change the battery in a Honda Accord?
Lester Moorman, If possible charge your battery 12.2V+ or change it, as this could continue happening. Try alarm rest procedure below. Insert the ignition key in the Accord’s driver-side door lock. Turn the key to the unlock position. Turn the key to the lock position. Turn the key back to the unlock position.
Why does my Honda Accord jerk while driving?
While driving car starts jerking violently for a few seconds then the check engine comes up. This happens sporadically but seems to happened after driving for long time at least 30 min or more. Any ideas are welcomed. Hi there, I previously owned an ’02 Accord, and had the similar issue.
How much does it cost to repair a p1381 Honda?
Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P1381 HONDA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
What does the p1381 Honda cylinder position sensor do?
P1381 Honda Description. The Crankshaft Position (CKP) Sensor determines timing for fuel injection and ignition of each cylinder and also detects engine speed.
What is the CYP sensor on a Honda Accord?
Cylinder Position (CYP) Sensor detects the position of No. 1 cylinder for sequential fuel injection to each cylinder. The CKP/TDC/CYP Sensor is built into the distributor.
P1381 Honda Description. The Crankshaft Position (CKP) Sensor determines timing for fuel injection and ignition of each cylinder and also detects engine speed.
Why does my Honda Accord Jerk when I slow down?
While driving this car 25 miles one way the jerking usually happens either while i slow down to 30-40 miles an hour or at the end of the trip when i get off the highway so at slower RPM.
While driving this car 25 miles one way the jerking usually happens either while i slow down to 30-40 miles an hour or at the end of the trip when i get off the highway so at slower RPM.
Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P1381 HONDA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
Cylinder Position (CYP) Sensor detects the position of No. 1 cylinder for sequential fuel injection to each cylinder. The CKP/TDC/CYP Sensor is built into the distributor.
What are the sensors on a Honda p1382?
The Cylinder Position (CYP) Sensor, Crankshaft Position Sensor (CKP) and Top Dead Center (TDC) Sensor are all built into the distributor. The cost of diagnosing the P1382 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
The Cylinder Position (CYP) Sensor, Crankshaft Position Sensor (CKP) and Top Dead Center (TDC) Sensor are all built into the distributor. The cost of diagnosing the P1382 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
While driving car starts jerking violently for a few seconds then the check engine comes up. This happens sporadically but seems to happened after driving for long time at least 30 min or more. Any ideas are welcomed. Hi there, I previously owned an ’02 Accord, and had the similar issue.
Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P1381 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.