Can you remove the interior trim?
1 Insert a pry bar at one set of nails and place a scrap of wood behind the bar to protect the wall. Pry gently outward to bow the molding away from the wall and loosen the nails. If a nail won’t pry out, use a nailset to drive it deep into the trim, then pry away the trim.
How do you remove the inside panel?
Take a flathead screwdriver and wedge it into the lower edge of the control panel, where it connects to the door panel. Use gentle pressure to pry it up and pop it out of place. The control panel is held in place by small connecting clips that can be easily damaged if you snap or jerk the screwdriver to remove it.
How hard is it to replace a rear quarter-panel?
Like all things in life, however, it’s not quite so easy. On the surface, it’s a simple job: cut the old quarter-panel off and weld a new one on. Like all things in life, however, it’s not quite so easy. Because you’re welding the new panel on, undoing a poorly done install can be a major pain in the butt.
Can a rear quarter-panel be replaced?
Rear quarter panel work will require more time and applied skills than the fender job. Welding will be necessary when this panel is being replaced. Also required is an exact paint match with the door, B-pillar (if applicable), roof, fascia and trunk lid.
How do I remove the right rear interior panel without?
If you need to remove the rear blower motor follow these instructions:” (1) Disconnect and isolate the battery negative cable. (2) Remove the right quarter trim panel and right D-pillar trim panel from the quarter inner panel (Refer to 23 – BODY/INTERIOR/QUARTER TRIM PANEL – REMOVAL).
How are rear trim panels held in place?
Basically the panels are held in place by little plastic pins that snap into holes in the underlying metal bodywork. In addition, the rear panel is held at the bottom by the sliding door threshold panel and the rear hatch threshold panel, and at the top by the pillar trim panels flanking the rear window. (These are called Pillars C and D]
What to remove from the rear of a Honda?
Put on gloves to protect your hands. Take care not to bend or scratch the trim and panels. Use the appropriate tool from the KTC trim tool set to avoid damage when prying components. Remove these items: Rear door sill trim Cargo area floor mat, cargo floor lid, cargo storage bin Rear trim panel Tie-down hooks
How to remove the trim from a Honda CRV?
-1 Open the lid (B) and remove the screw (C), then remove the cargo hook (D).-2 Release the hooks (E), then remove the jack cover (F).-3 Remove the clip (G), then pull the trim panel back by hand to detach the clips (H, I).-4 Release the hooks (J) from the C-pillar trim (K) and D-pillar trim (L), then pull the trim panel forward.