What is an intake camshaft position actuator circuit?
Vehicles equipped with variable valve timing (VVT) use a special solenoid called a Camshaft Position Actuator. This solenoid is capable of regulating the oil pressure thus controlling the cam timing. The P0010 code is set when the ECU detects a low voltage in the VVT circuit corresponding to the bank 1 intake cam.
What does error code P0010 mean?
P0010 is a generic OBD-II code indicating an issue with the engine control module (ECM) detecting a variation in the mechanical timing between the crankshaft and bank 1 camshaft. The timing issue is typically detected during higher RPMs of the engine when the ECM attempts to adjust valve lift during higher speeds.
How much does it cost to replace a camshaft position actuator circuit?
In a lot of cases, you will have to pay for multiple parts which can cost $1,000 or more on high-end cars. Since it can take hours to replace the actuator, you can expect to pay hundreds of dollars in labor, usually starting at around $300 and going up to $1,000 or more.
What causes a camshaft actuator to go bad?
Over time, the camshaft position sensor can fail, or become worn down, due to accidents or normal wear and tear. There are a few warning signs to watch out for before your camshaft position sensor completely fails and shuts down the engine, making replacement a necessity.
Where is the camshaft actuator located?
Replacement Intake & Exhaust Camshaft Position Actuator Solenoid Valves – These actuators located on the cylinder head of your vehicle control the position of the camshafts.
What are the symptoms of a bad cam position sensor?
Symptoms of a failing cam or crank sensor are generally the same, and include poor acceleration and gas mileage, misfires, rough idle, stalling, and a check engine light. When the camshaft position sensor fails completely, the engine will not start or will shut off if it fails during operation.
Where is the cam position sensor located?
The camshaft position sensor is either located near the top of the engine, passenger-s side, or on the right side of the engine near the ignition coils. The camshaft position sensor is located on the engine near the camshaft pulley.
What does a cam position sensor do?
The CAM sensor or camshaft position sensor’s role is to signal the ECM the camshaft position. The crank and cam sensor operates in sync with eachother. The CAM sensor is frequently used in determining which injector to fire in a sequential system and for the COP or coil on-plug ignition systems coil firing event.
Where is can shaft position sensor located?
The camshaft position sensor is always located near the camshaft , often at the top of the valve cover, but it can also be installed from the side of the cylinder head. Check around the head or valve cover and follow any electrical wires and you will for sure find the camshaft position sensor.