How do I reset my air intake sensor?
- Start engine and warm it up to normal operating temperature.
- Turn ignition switch OFF.
- Disconnect mass air flow sensor harness connector.
- Restart engine and let it idle for at least 5 seconds.
- Stop engine and reconnect mass air flow sensor harness connector.
- Make sure DTC P0102 is displayed.
- Erase the DTC memory.
What happens when you unplug the mass airflow sensor?
If you disconnect the mass airflow sensor, then the car should keep running and still be able to start normally. This means that if your mass airflow sensor dies completely, then your car will stay running and surprisingly the car might run better without the mass airflow sensor.
What is the code for the intake air temperature sensor?
Meanwhile, a sensor that produces a low voltage input merits the trouble code P0112. P0098 is the mirror image of P0113 since it reports the same issue of low temperature, higher electrical resistance, and high signal voltage in sensor 2, the second IAT sensor in the engine.
Where is the IAT sensor in the intake manifold?
It can be located on the air cleaner, in the air inlet tube, or in the intake manifold. The IAT sensor is a two-wire sensor with a negative temperature coefficient resistor positioned so that it reads the air entering the engine.
What should I use to clean my MAF sensor?
Use mass air flow sensor cleaner (DO NOT SUBSTITUTE FOR ANY OTHER KIND OF CLEANER) to clean out the MAF sensor. Do this by spraying each side of the MAF sensor for 3-5 seconds, waiting 10 seconds, and then spraying it again for 3-5 seconds.
How much does it cost to replace an intake temperature sensor?
If your intake temperature sensor is integrated into the MAF sensor, the part cost can increase rapidly. Some MAF sensors cost up to 400$. The replacement of a MAF sensor or intake temperature sensor is often very straightforward and can often be made yourself with basic knowledge.