How do you reset the fuel gauge on a Toyota Tacoma?
Turn off the ignition switch. Depress and hold the “ODO/TRIP” button while turning the ignition switch to the “On” position. Hold the ODO button for two seconds. Release and press the ODO button three more times within five seconds: Release-Press-Release-Press-Release-Press and Hold.
How do I fix my fuel gauge meter?
How do you fix an inaccurate fuel gauge?
- Turn the ignition on and off a few times, and observe if the needle on the fuel gauge moves.
- Test the grounding wire on the sending unit of the fuel tank.
- Disconnect the wiring connected to the sending unit of the fuel gauge and then look at the fuel gauge.
Is gas gauge expensive to fix?
The majority of the time it is the fuel gauge sender which is the problem. This part can be a bit pricey to repair and most of the expense is in labor costs. Depending on the make and model of your car and the specific sender that you purchase, costs will run on average between $250 and $800.
How do you test a gas gauge?
Turn on the engine’s ignition and probe with a multimeter between the ground and the positive terminal on the back of the gauge; it should be marked with a “+” or an “I.” If there is no voltage then the fault is in the ignition circuit—and the gauge is probably good.
What kind of fuel tank does a 2004 Tacoma have?
Discussion in ‘ Technical Chat ‘ started by spunky1, Sep 17, 2006 . I have a 2004 regular cab, 4 cylinder Tacoma. All of a sudden, I am unable to fill the fuel tank like I used to. When filling, the tank acts like it is full or obstructed.
How long does it take to fill a Tacoma fuel tank?
When filling, the tank acts like it is full or obstructed. I have to pull the fuel nozzle way out and trickle the gas in or the fuel will back up in the neck and shut off the nozzle. It can take 15 minutes or more to fill from empty. Does anyone know what the cause of this could be? 4x4Runner Now with more Oi Vey! Moderator
Where does the gas nozzle end on a Tacoma?
The vent nozzle, if I remember this right terminates in and around the gas filler port. Your vent pipes along with excess fuel return should be all clumped together around the sending unit on top of the tank.