How do you disconnect a headlight connector?
Just push down on the clip and pull it off. It doesn’t take much force to release the clip, but the silicone seal makes it tough to start. Wiggle it a bit. Be careful in colder weather, it can snap if you push the clip too hard…
How do you remove corrosion from headlight connectors?
Be suspicious of corrosion Clean the socket with electrical contact cleaner, which is available at auto parts stores. If you see heavy corrosion, scrape it off with a small screwdriver or wire brush.
How do you test a headlight connector?
Determining the Ground Wire
- Remove the connector from the back of the headlight.
- Trace the wires back from the connector as far as you can see them.
- Turn on the ignition of the vehicle and turn on the headlights to high beam.
- Set the multimeter to DC Volts to measure 12 volts.
How big is a Dorman headlight socket plug?
Ignore the pictures with the orange socket + plug, this product – dorman 84790 – is actually the socket with rubber boot and no plug. quality seems OK (wires are pretty small gauge, but are acceptable for a 3 inch length..), but the product images are wrong, so I didnt get what I needed.
What kind of wire to use for headlight socket?
The neoprene boots are good and thick and fit securely on the sockets and 18 gauge wire is plenty for a short run from the factory harness to the sockets. These are fine for me. These things are great quality. The wire is plenty thick enough.
Where is the Dorman Auto Parts Company located?
Dorman is a leading auto parts manufacturer founded in the United States and headquartered in Colmar, Pennsylvania. Our story began with the first mass market automobile. We were one of the first companies to deliver replacement products for the automotive aftermarket, and we remain at the forefront today.