Why is my coolant fan not working?
Defective temperature switch, coolant sensor or other sensor. Engine thermostat is stuck OPEN (engine never gets hot enough to turn on the fan) Faulty fan relay. A wiring problem (blown fuse, loose or corroded connector, shorts, opens, etc.)
How do you check a coolant fan?
How to Check a Radiator Fan
- Determine whether your radiator fan is manual or electric.
- To check an electric radiator fan, start the car and let it get up to the temperature where the fan normally kicks on.
- Use the volt meter to test if there is power to the wires.
- Normal voltage for a radiator fan is around 12 volts.
What will a bad temp sensor do?
If the coolant temperature sensor goes bad it can send a false signal to the computer and throw off the fuel and timing calculations. It is not uncommon for the coolant temperature sensor to fail and send a permanently cold signal to the computer. This will reduce fuel economy, and may hinder engine performance.
Where are the fuses on a Toyota RAV4?
Fuse box diagram (fuse layout), location, and assignment of fuses and relays Toyota RAV4 (XA40) (2012, 2013, 2014, 2015, 2016, 2017, 2018). The fuses are designed to blow before the entire wiring harness is damaged. If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary.
What should I do if my radiator fan is not working?
A blown fuse is no big deal, and changing one does not cost a lot of money. If your car’s radiator fan is non-functional, check your car’s user manual and locate the fuse for the radiator fan controller or the fan. The fan itself often uses a big fuse of around 50A, while there might also be a separate small fuse to the fan control module.
Is there a way to test a radiator fan?
You can test the electrical radiator fans by taking a wire from the car battery, unplug the radiator fan connector, and put 12v+ and ground into the connector. This is the fastest and easiest way to test your radiator fans. Because the radiator fan is often drawing so much power, there is often a relay that is powering the coolant fan.
Where is the relay on a radiator fan?
The fan relay is often located in the engine bay’s fuse box, but the best way is to check your repair manual to find where it is located. Testing a 4 pin relay is often very straightforward. Remove the relay and give 12 volts to pin 30 and 85. Ground pin 86 and check if there is voltage coming out from pin 87.