Why is my Tacoma AC light blinking?
A flashing light usually means the system has detected a problem and shut down the compressor to prevent it from locking up and stalling the engine. Don’t forget to inspect the belt as well. A loose belt can make the system think the compressor is seizing.
How do you reset the TPMS light on a 2006 Toyota Tacoma?
You will need to press and hold the tpms reset button to reset the tire pressure light on a 2006 Toyota Tacoma and allow the light to blink 3 times. Once You have done this step You can then turn the car on and leave it running for approximately 5 minutes to allow it to reset completely.
Why is my car AC light blinking?
-When a blinking light problem occurs, your air conditioning system often shuts off too, meaning warm air is blown. You can switch off the circuit breaker of your AC unit, wait for a few seconds, and then switch it on again. For some, the unit will start working normally again.
How do you reset the TPMS light on a Toyota Tacoma?
How to Fix the Low Tire Pressure Light on My Toyota Tacoma
- Park the vehicle on a level surface and turn it off.
- Start the vehicle.
- Press and hold the TPMS reset button, located below and to the left of the steering wheel.
- Wait an additional five minutes with the vehicle running, then shut it off.
What does low pressure warnning light on Toyota Tacoma mean?
When the computer determines that the pressure in one or more of the tires is too low, a low pressure warnning light is illuminated on the dashboard. It is important to keep the tires properly inflated to ensure that the Tacoma will handle properly and safely.
Why is the a / C light blinking on my truck?
What was happening with my truck was I would turn on the a/c, the compressor would kick in and cold air would just start to blow before the light started blinking. The magnetic clutch would kick out right when the light started blinking and then it would just blow warm air.
How to remove TPMS light from Toyota Tacoma?
You can then get your fingers under the bottom edge of the panel and pop the upper corners loose. Simply press down on the tabs (indicated by yellow arrows in the picture below) and pull the connectors straight out.
What’s the problem with my Toyota Tacoma 4×4?
Im working on a 2005 toyota tacoma 4×4 with a 2.7 litre engine ps, mt, ac. The ac light is blinking. I replaced the mag/clutch relay plus the amplifier; but the light is still blinking. Any ideas???? … read more I have a 2006 toyota tacoma. The problem is with the A/C. The light comes on but nothing happens. What’s the problem? … read more