How do you check the transmission fluid on a 2004 Honda Element?
How do you check the transmission fluid on a 2004 Honda Element? The automatic transmission fluid level is checked (with the engine off and the car on level ground) using the dipstick (with the yellow marking) in the right end of the transmission housing. Remove the dipstick and wipe it off.
Where is the transmission dipstick on a Honda Element?
The automatic transmission fluid level is checked (with the engine off and the car on level ground) using the dipstick (with the yellow marking) in the right end of the transmission housing. Remove the dipstick and wipe it off.
What kind of transmission fluid does a 2003 Honda Element take?
Lubegard Synthetic Synthetic Transmission Fluid Dexron VI 1 Quart.
Why is my Honda Element D drive light blinking?
My Honda Element “D” Dashboard Drive Light was blinking and it turns out it was a Pressure Switch Sensor at the 3rd Gear Clutch Low Circuit with Error Code on the Transmission Computer of P0847. Category Autos & Vehicles Show moreShow less Loading… Advertisement
Why does my Honda Element Flash when I start it?
The automatic transmission, when it is in drive in other words will flash after I start it and drive for a couple of minutes. At the dealership they say I need a new ECU or some kind of Electronic control module.
Where is the DTC connector on a Honda Element?
Turns out all you have to do is locate the DTC connector by your right knee under bottom of dash, it points downward. Make sure key is out of ignition, Lay on your back, insert wire between pin 4 and pin 9.
My Honda Element “D” Dashboard Drive Light was blinking and it turns out it was a Pressure Switch Sensor at the 3rd Gear Clutch Low Circuit with Error Code on the Transmission Computer of P0847. Category Autos & Vehicles Show moreShow less Loading… Advertisement
The automatic transmission, when it is in drive in other words will flash after I start it and drive for a couple of minutes. At the dealership they say I need a new ECU or some kind of Electronic control module.
Turns out all you have to do is locate the DTC connector by your right knee under bottom of dash, it points downward. Make sure key is out of ignition, Lay on your back, insert wire between pin 4 and pin 9.