How do you change a blend door actuator?
You will need a tool set including an 5.5 mm socket for Chevy, GMC, Cadillac, Ford and Lincoln vehicles.
- Step 1: Remove the Lower Dash Panel or Glove Box.
- Step 2: Remove the Door Actuator.
- Step 3: Remove the Actuator.
- Step 4: Turn the Air Door Pivot.
- Step 5: Match the New Actuator.
How long does it take to change a blend door actuator?
Replacing the blend door actuator is actually a fairly simple process, and it should take no more than an hour. So the labor will cost you around $75 – $150 depending on labor rates at your local repair shop. In general, you can expect the total cost to be no more than $400.
How much does it cost to repair a blend door actuator?
Blend door actuator repair cost. The cost of repairing the blend door actuator, as with most car repairs, will depend on the mechanic you hire, your geographical region and the car you drive. Most of the repair quotes we researched online ranged anywhere from $75 to $275 for both parts and labor. As with most car repairs,…
How do I remove blend door actuator?
Begin by using a small screwdriver to release the wiring safety clip on the harness for the actuator. These clips can be brittle and break so be gentle. Once released gently pull down on the wiring connector and remove it from the blend door actuator.
Where is the actual blend door actuator located?
The blend door actuator is typically located closer to the heater core and evaporator than the mode door. The mode door actuator controls which vent (s) air blows through.
What does a blend door actuator do?
Blend door actuators, also called HVAC actuators, control the position of the vents that control the flow of air into your vehicle’s passenger area. The actuators are small electric motors that move the vent doors, mixing hot air with cold air to achieve the temperature that you desire.