How do you remove an airbag module?

How do you remove an airbag module?

Steps to remove airbag control module

1. First, find the SRS computer module. In most cars, it is under the center console that is between the two front seats, or center of the dash on the floor.
2. Disconnect the positive battery cable and wait 3 min.
3. You are now safe to unplug the airbag control module harness wiring plugs.

What happens if you unplug airbag module?

What happens if you unplug airbag module? How Do I Disconnect the Airbag Control Module? Disconnecting the airbag unit from the harness without unplugging the battery may trigger the airbags to deploy or may cause damage to the computer system.

How much does it cost to reset airbag module?

The dealership will not be able to clear hard code due to hardware issues and will offer to sell you a new replacement airbag module that usually costs around $180 to $600 depending on the vehicle. At MyAirbags, we reset ALL fault codes.

Can you drive a car without airbag module?

While a vehicle can still run without an airbag module, it is strongly recommended that drivers do not operate the vehicle without it being installed—unless an emergency situation arises and there is no other option. Without airbags deploying, a driver and any passengers can face severe injury or even death.

How to remove the SRS airbag control module?

Steps to remove airbag control module 1 First, find the SRS computer module. In most cars, it is under the center console that is between the two front seats, or center of the dash on the floor. 2 Disconnect the positive battery cable and wait 3 min. 3 You are now safe to unplug the airbag control module harness wiring plugs.

Where do you remove an air bag in a car?

The next is a repair that requires the removal of an airbag that needs to be done such as a turn signal switch which is located behind the steering wheel. Other repairs include the removal of a side air bag such as a window regulator replacement job. As you can see by the image below the side airbag stands in the way of the window regulator.

How do you install an airbag control module?

All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.

Is it possible to reset an airbag module?

You are now able to re-use your existing airbag module with our reset service! Your module will be restored back to its factory condition and will not require any additional programming. Just Plug & Play! This service is 100% compatible with our seat belt repairs.