Where is the mode door actuator located?
Where is the heater blend door actuator located? The Blend Actuator Motor is located on the Hvac Box underneath the dashboard.
Where is the blend door located on a 2000?
There are two blend doors, one located on the driver side and another on the passenger side.
What controls the blend door actuator?
Actuator is basically another word for motor. The blend door actuator is a small electric motor that features sensors connected to your car’s climate control system. There should be controlled by some plastic gears that are responsible for moving the blend door where the actuator sends the correct signals.
How do I know which blend door actuator is bad?
Suppose you hear a droning or faint clicking repetitively from the dashboard, around the center area, where your HVAC system control knobs are located. In that case, that indicates you have a bad blend door actuator. A faint clicking or droning sound underneath the dash is usually a blend door actuator noise.
What are the symptoms of a bad blend door?
Here are some of the most common symptoms that a blend door actuator has gone bad:
- Clicking Sound. If you hear a repeated light clicking sound coming from under the dash, it can be a bad blend door actuator.
- Wrong Temperature.
- Two Different Temperatures.
Where is the air distribution blend door motor?
The air distribution blend door motor is on the driver side of the plenum and the steering column must be removed. Here are the removal and Installation instructions for the steering column: NOTE: Removal steps in this procedure may contain installation details. Remove the steering column shrouds.
Where is the blend door actuator on my 2013 Fusion?
While using my A/C the driver’s side vents blow cold air but the passenger side vents blow warm air. I suspect the passenger side blend door actuator is the culprit. I’m unable to find good information on the location of this component for the 2013 and newer model year Fusions.
What’s the name of the blend door actuator?
This is actually called the distribution actuator. The blend door actuator is what mixes the air to give you the temp that you are requesting. I attached the process. Unfortunately they say you need to remove the steering column. I attached that process as well. Let me know if you have questions. Thanks helpful?
How much does it cost to replace a passenger blend door actuator?
Between your post and that one, there should be no reason anyone with a little bit of skill and physically able to should have to pay the $400.00-$600.00 some dealers are charging to change an actuator. Just replaced the passenger blend door actuator on our 2010.