How do I fix error code P2111?
What repairs can fix the P2111 code?
- Replace the TPS. Commonly this will require the throttle body to be replaced as the TPS and the throttle body is an integrated unit.
- Clean the throttle body.
- Replace the throttle body.
- Replacing the PCM. (
- Repair the wiring.
How do you fix a throttle actuator control system stuck closed?
So here are some ways with which you can correct this issue:
- The damaged wiring harness must be repaired.
- The throttle position sensor needs replacement.
- Fixing the damaged throttle body actuator.
- The electrical connection point which is faulty needs fixation.
- The throttle body plate must be released.
Where is the throttle actuator control module located?
The TAC module is mounted on the driver’s side firewall under the corner brace.
How do you test a throttle actuator?
Turn the ignition OFF, disconnect the harness connector at the throttle body. Turn the ignition ON, test for 0 volts between each motor control circuit terminal E and F and ground. If greater than 0 volts, test the affected motor control circuit for a short to voltage. If the circuit tests normal, replace the ECM.
How much does it cost to replace a throttle actuator control system?
To replace your car’s throttle body, you will pay as little as $370 or as much as $1,500. Labor should be between $70 and $260, and parts should cost you from $110 to $600.
What causes P2112 code?
P2112 is a general ODB2 diagnostic trouble code indicating a fault with the throttle actuator control system. This code may be seen with other throttle body codes. The Engine Control Unit (ECU) detects the throttle plate actuator stuck closed and triggers a Check Engine Light to be set on the dashboard.
What causes a car to have a p2111 code?
Common Causes Of A P2111 Code. Possible causes of this code may include: Faulty throttle body. Dirty throttle plate or linkage. Faulty throttle position sensor. Defective accelerator pedal position sensor. Throttle actuator control motor is defective. Corroded or damaged connector.
When to set the p2111 code on the TAC?
Code P2111 can be set when: the idle position set inside the memory of the PCM does not match the stored TPS voltage when it was closed (idle), or it does not match the actual voltage being sent back from the TPS when the TAC/ETC motors are commanded to the closed position. Note: This code is particularly common on late model Fords.
Can a marginal battery set a p2111 fault?
Marginal/weak batteries have been known to set an intermittent P2111 fault code. Diagnose current faults first, in the order in which they are stored. Misdiagnosis occurs when this code is diagnosed when it is a stored code, especially while other codes are active.
What to do if your p2111 throttle is stuck?
If you have a P2111 and/or P2112 code with that vehicle, here is a PDF copy of the full TSB 10-21-6 bulletin . The fix involves replacing the throttle body with either part number 7T4Z-9E926-FA or 8S4Z-9E926-B.