Where does the fuel pump connect to?
Because it is connected to the camshaft, the discharge pressure of these pumps is constant, but the rate at which it pumps is directly correlated to the revolutions per minute (rpm) of the engine. Both pumps create negative pressure to draw the fuel through the lines.
Can you wire fuel pump to battery?
Yes, they both go to the positive side of the battery.
How do you wire a fuel pump relay?
Wiring in the Fuel Pump Relay
- Wire pin 85 of the relay to the 12v supply wire from the stock ECU that you just cut.
- Wire pin 86 to a good ground on the car.
- Run a dedicated wire from your battery to pin 30 on the relay.
- Run a wire from pin 87 to your factory wire that you cut that runs to the fuel pump.
Does electric fuel pump need a relay?
It depends on how long the wire run is, how thick the wire is, how much current the pump draws, and what other types of controls you want on the pump circuit. Low current pump, short heavy wire, no funky control requirements means you can go without a relay.
How do you test a fuel pump connector?
Use the jumper wire to power the fuel circuit and energize the pump. Connect the digital multimeter to the battery and the pump, both on their negative terminals. Conduct the tests using a live circuit wire. If the meter indicates a reading of more than 0.1 then this indicates a loss of voltage power.
How can I check if my fuel pump is working?
Before you check your fuel pump, find the fuse that corresponds to the pump and pull it out to see if it is broken or burned. If it looks fine, check the voltage at the pump itself to make sure the charge that’s leaving the fuse gets to the pump. If this looks alright, then perform a fuel pressure test.
How to fix ground wire from fuel pump connection?
Same with the power wire from the relay to the fuel pump connector.You can also try sliding the wire between two fingers while slightly bending the wire to feel for a soft spot but this may not work due to the fact that it works sometimes so the bad spot isn’t real big yet. 5 people found this helpful.
Where is the test point for a fuel pump?
Hook the pressure gauge to the fuel pump test fitting. Locate your fuel pump test point, which is usually near the fuel injectors, and locate the point at which the pump hooks up with the filter injector rail. There should be a separation joint or a test port, where the pressure gauge attaches.
Where can I get a fuel pump gauge?
Get a fuel pressure gauge. Commonly available at most auto parts stores for $20-30, a pressure gauge is a good investment, useful on most makes and models of cars. If you don’t want to buy one, you can also often borrow one from machine shops or auto shops who have them to lend.