What is the torque spec for camshaft?
Hand tighten the camshaft cap bolts numbered: 5, 7, 2, and 4. Install all the bolts and tighten, in sequence, in 5-6 steps with a final torque of 100-125 inch lbs. (11-14 Nm).
What is the torque spec for a Toyota Tacoma?
When installing a wheel on your Toyota Tacoma, you must torque the lug nuts to the manufacturer’s recommended lug nut torque of 83 ft-lb, or 113 Nm (you can go as high as 85 ft-lb).
How do you torque a cam cap bolt?
Torque the bolts in 2-3 steps to 125 inch lbs. (14 Nm) in the proper sequence. New camshaft seal by lubricating it with engine oil. Tap the seal into position, using a seal installer, until it is flush with the edge of the camshaft cap on 1.8L (BP) and 2.0L engines or recessed into the cylinder head 0.012-0.027 in.
How do you torque aluminum heads?
Torque to 70 ft/lbs. for 7/16″ bolts or studs (289 or 302) or 100 ft/lbs. for 1/2″ bolts or studs (351W) in three or four steps following the factory tightening sequence. Then tighten the long (upper) head bolts or studs to 80 ft/lbs.
What are the steps to remove a camshaft?
Remove the central bolt to take the sprocket from the camshaft. Slacken the cam-cover bolts evenly so that the valve-spring pressure is released slowly. When all the bolts have been removed, take off the cover with its integral bearing caps. Lift the camshaft from the cylinder head complete with the front oil seal .
What are camshaft caps?
The Tombstone camshaft cap As with most camshaft caps, its primary function is retention of the camshaft to the cylinder head for structural support.
What are the torque specs for a Tacoma?
I put together a collection of some of the most-common Torque Specs and Diagrams. These are all from the 2006 FSM. Here is a Torque Extension Converter that @tyfoon11 found – VERY handy if you are using extensions/adapters to adjust your torque settings accordingly.
When did the 2nd Gen Tacoma come out?
Discussion in ‘ 2nd Gen. Tacomas (2005-2015) ‘ started by Benson X, Mar 1, 2014 . Benson X [OP] My build thread sucks… If you don’t draw blood, you’re doing it wrong! I put together a collection of some of the most-common Torque Specs and Diagrams.
How to get full access to Tacoma World?
Welcome to Tacoma World! You are currently viewing as a guest! To get full-access, you need to register for a FREE account . Discussion in ‘ 2nd Gen. Tacomas (2005-2015) ‘ started by Benson X, Mar 1, 2014 .