How do you disconnect a hybrid battery?
How to Disconnect Hybrid Batteries
- Make sure the vehicle is turned off.
- Prop open the hood and remove the liner, if necessary.
- Disconnect the negative cable from the battery.
- Wait 15 minutes after you disconnect the battery before attempting mechanical or electrical repairs.
How do you charge a Toyota Highlander hybrid?
The gasoline engine also powers an electric generator to recharge the battery pack; unlike a pure all electric vehicle, the HIGHLANDER Hybrid never needs to be recharged from an external electric power source. Depending on the driving conditions one or both sources are used to power the vehicle.
Can you disable hybrid system?
Although the high voltage (HV) systems of most hybrids do not normally need to be disabled when performing routine maintenance, HV systems must be shut down before high-voltage cables or components are disconnected or removed.
Can you turn off the hybrid?
You’re probably already familiar with the effect that a hybrid drivetrain has on fuel economy, but now one of the key concepts of a hybrid drivetrain — the ability for the engine to turn off and on automatically at stoplights — is being introduced in conventional gasoline-engined cars.
When to not use power outlets in Toyota Highlander?
Do not use a 120 vac appliance that requires more than 100 w. If a 120 vac appliance that consumes more than 100 w is used, the protection circuit will cut the power supply. Do not use the power outlets longer than necessary when the engine is not running.
Where is the ignition switch on a Toyota Highlander?
Open the lid. Open the console box lid (→p. 447) And open the lid. Open the lid. Vehicles without a smart key system: the engine switch is in the “acc” or “on” position. Vehicles with a smart key system: the engine switch is in accessory or ignition on mode. The engine switch is in ignition on mode
How to replace rear drive shaft in Toyota Highlander?
REPLACEMENT HINT: Differential components (See page 29-3 ) Rear drive shaft components (See page 30-4 ) Replace the RH side following the same procedures as with the LH side. 1. REMOVE REAR WHEEL 2.