How long does it take to change water pump and serpentine belt?
Changing a timing belt and water pump can take anywhere from 1-3 hours depending on your skill level, so make sure you have the time and space to complete the job. Do the following before you start: Jack up the front of the car so you can access the undercarriage beneath the engine.
How do you change a water pump on a Toyota Highlander?
Loosen the bolts and remove the old water pump. Remove the old seal/gasket or old sealant remains and make sure the mounting surface is clean. Before installing the new water pump, inspect the other cooling system service parts: coolant hoses, thermostat and pressure cap(s). Install the new water pump.
How much does it usually cost to replace a water pump?
The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314.
How much does it cost to replace a water pump in a Toyota Highlander?
The average cost for a Toyota Highlander water pump replacement is between $1,565 and $1,935. Labor costs are estimated between $1338 and $1689 while parts are priced between $227 and $246. Estimate does not include taxes and fees.
When to replace the water pump in your car?
As Stillrunning states, replacement cost is mostly labor. At next belt change if you still have the car, put a new waterpump in. When the pump starts to fail it usually give some indication such a leaking, noise, car overheating, etc. Also check the threads at the bottom of this page. When the car starts to overheat, replace it….
What happens if your Toyota water pump fails?
If your timing belt fails in a non-interference engine, you’ll be stranded on the side of the road, if your water pump fails you’ll either a)be left on the side of the road or b)cause engine damage. Peace of mind is worth something, that’s why we’re willing to pay more for a Toyota :whatwhat:
How do you replace a water pump on an Audi A3?
A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench. For applications where the water pump is driven by the timing belt, the timing belt must be removed.