How do you turn off daytime running lights on a Toyota Corolla?
This is especially helpful in the periods right after dawn and before sunset to increase visibility to other motorists. If your vehicle is equipped with a “DRL OFF” setting, they can be turned off by twisting the headlight control knob to “DRL OFF.”
How do you turn off daytime running lights on a 2002 Toyota Corolla?
How to Disable the Toyota Daytime Running Lights
- Turn off the Toyota vehicle’s engine.
- Open the glove box. Locate the headlight module at the back of the glove box.
- Unplug the harness from the module and pull the module out of the vehicle. Cut the DRL pin and place the harness back into the glove box.
How do you turn on daytime running lights at night?
To activate your daytime running lights, you must:
- Have the ignition in the on position.
- Turn the headlights off, or put them in parking light mode, or auto light mode.
- The system should automatically turn on if these conditions are met.
Where is the daytime running light module?
Typically, the daytime running light module is located under the dash or in the engine compartment. The exact location can be found in the vehicle repair manual.
How do you disable daytime running lights on a Toyota?
Toyota vehicles have a different method of disabling their daytime running lights than most vehicles. Instead of pulling a DRL fuse, Toyota vehicles have a specific pin on the headlight relay that you must cut to disable the daytime running lights.
Where are the running lights on a Toyota?
The headlight is located in the glove compartment in the fuse and relay center. Although the daytime running lights may limit the life of your high beam bulbs, they are a safety feature that is mandatory in many countries.
What happens when you turn off the daytime running lights?
When the headlamp switch is engaged, the daytime running lamp function is disabled and the low beam filaments receive 100% system voltage. What it means: The DRL Relay Block enables power to the low beams and the resistor changes the voltage going to the low beams from 12 volts to 10 volts thus making them dimmer.
How to wire DRL’s so they turn off when my lights?
In addition, any local auto electrician should be able to set this up for you if needed. Please note that this diagram assumes a positively switched vehicle – and will need to be modified to suit a vehicle with negatively switched headlights.