How much is a starter for a Toyota Matrix?
The average cost for a Toyota Matrix starter replacement is between $300 and $335. Labor costs are estimated between $56 and $71 while parts are priced between $244 and $265. This range is based on the number and age of Toyota Matrix’s on the road.
Where is the starter on a Toyota?
The starter is located on the passenger’s side of the engine near the bottom. You can access the starter from the top in the engine compartment but if you have cruise control, you will have to move a couple of components from the engine compartment first.
Is the Toyota Matrix a Corolla?
Officially sold in North America until being discontinued, the Matrix was positioned as a sporty hatchback counterpart of the North American Corolla and was counted as a variant of it in Toyota’s sales figures. Sales of the Matrix were discontinued in the United States in 2013 and in Canada in 2014.
How much is a starter for a 2010 Toyota Matrix?
2010 Toyota Matrix Starter – from $147.99+ | AutoZone.com.
How much is a starter for 2006 Toyota Matrix?
2006 Toyota Matrix Starter – from $103.99+ | AutoZone.com.
Do you need to replace the starter on a 2003 Toyota Matrix?
If you need to install a new starter on your 2003 Toyota Matrix, you need to remove the old broken one first. Fortunately, the process of replacing the starter in the Toyota Matrix is not much different then changing one in a domestic engine.
How do you change the starter on a Toyota?
To do that, you can either just remove the starter and jump the terminal or try and run a jumper wire to the solenoid terminal on the starter with the starter on the car. Basically, you will unhook the solenoid wire and jump the the terminal of the wire to the battery terminal positive.
How do you remove starter solenoid from Toyota?
Remove the two bolts that secure the starter to the engine block and pull the starter out of the engine. Use a boxed wrench or socket set to remove the bolts. Remove the two bolts that secure the starter solenoid to the starter. Pull the solenoid off the starter. Use a boxed wrench to remove the bolts.
How do you remove a starter from a car?
The starter is now visible. Remove the black wire from the rear of the starter by pulling outward on the cable connector. Remove the gray rubber cap off the starter. Remove the 10mm nut that secures the ground wire to the starter. Remove the two 14mm bolts that secure the starter to the engine. One bolt connects to the bell housing.