Where is the fuel pump shut off switch location?
Look for the fuel pump switch or inertia switch. This is a small box with a plastic button on top and an electrical connector at the bottom. On some vehicle models, this will be located in the luggage compartment. Look on a side panel for a small, round button which you can pry off with a small screwdriver.
Where is the inertia switch located?
The inertia switch is located behind the trim on the left-hand side of the vehicle, forward of the front door post, below the fascia.
How do I know if my fuel cut off switch is bad?
Symptoms of a Bad or Failing Fuel Pump Shut Off Switch
- Engine suddenly stops while driving. One of the first symptoms of a potential issue with the fuel pump shut off switch is an engine that suddenly stalls while driving.
- Switch that trips for no reason.
- No start condition.
What does the fuel reset button do?
In the event of an accident, the “Fuel Reset Button” will turn off the fuel pump and system.
Where is the fuel pump shut off switch located?
On Ford, Peugeot, VW, Citroen, Vauxhall, Subaru, Renault, Toyota and Mazda, inertia switch location is usually on one of the following two hidden places: Behind or below glove compartment, sometimes hidden under the carpet; On the driver side, between the footrest area and door, sometimes hidden under the carpet.
How does the fuel cut off switch work?
The fuel cutoff switch can cut off the flow of electricity going to the fuel pump stopping the flow of fluid to the engine. If your vehicle is overturned this switch activates as well.
How can I reset the fuel cut off?
This is similar to an electrical circuit breaker in your home which can be easily reset by pushing the button or pulling the leverage down. All modern fuel injection cars are equipped with an inertial fuel cut off switch that shuts off the power supply for the fuel pump if the vehicle is in a collision.
Where is the fuel cut off switch on a Ford Fiesta?
Steps to Locate and Reset Fuel Cut Off Switch on Ford Fiesta (For Other Cars Keep Reading) First, open the glove compartment. Pull out the glove compartment by firmly pressing the left side toward an inner section. Look for a device with a rubber yellow cap on it. Push the rubber yellow cap on inertia switch.