Where is the low pressure side of the AC?
The low side service valve is located in the line that runs from the compressor through the evaporator (firewall) and up to the condensor on the low pressure (suction) side of the system.
Which side is suction side of AC compressor?
The low side, or suction line, will be the line connected to the compressor from the top or higher position. It will be cold to the touch and may be wrapped with insulation. This is where freon enters the compressor as a gas.
Is the suction side the low pressure side?
Proper Pressure The suction side of the unit consists of the lines that lead into the compressor, often called the low side of the refrigerant system, since the pressure in these lines is much lower to the lines on the compressor output.
Where is the low side fitting?
The LOW side fitting is usually located on the suction hose or line that goes from the accumulator to the compressor. The HIGH side fitting is located on the line that goes from the compressor to the condenser.
What should AC low side pressure be?
The low-side should be near 30 PSI at 90 degrees Fahrenheit or less. Pressure that is too much lower or higher shows there is a problem. On a properly working system, high-side pressure will be about twice the ambient temperature, plus 50 PSI.
How do you tell a high side from low side AC?
The low side line of the system will have a larger diameter metal pipe than the high-side. The low side service port is usually located between the AC compressor and evaporator. The low side service port will have a black or blue plastic cap that needs to be removed.
What color is high side on AC?
red
Manufacturers color-code the hoses to distinguish between high pressure and low pressure. Low-side hoses are blue while the high side is red.
Is suction line Hot or cold?
When the system is operating, the large insulated suction line should be cold to the touch and sweating at any point where there is no insulation. The smaller uninsulated liquid line should be warm to the touch after the system has been operating for 10 or 15 minutes.
Do you charge AC on high or low side?
You only add refrigerant to the low side of the AC system. This helps draw in the refrigerant and prevents damage to the compressor. Normally the fittings are also different on the high/low sides to help facilitate this.
Why is the low side pressure on my AC too low?
Possibility #2 AC low side pressure is too low because the expansion valve or orifice tube is stuck closed or clogged In this case, the compressor is running and try to remove refrigerant gas from the evaporator.
Where is the low pressure air conditioner Charger?
The first step in recharging your system is to locate the low side service port (or low-pressure port). Every auto air conditioning system has two service ports: one on the high pressure and one on the low pressure side. When recharging with AC Avalanche refrigerant, for safety, you will charge through the low side service port.
What should the pressure be on a Toyota air conditioner?
If your Toyota’s air conditioning refrigerant recharge kit is equipped with high- and low-pressure gauges, you can use them to help identify when your vehicle’s refrigerant level is adequately pressurized. The low-pressure gauge should read between 25 and 40 psi (pounds per square inch).
Where is the low side service port on an air conditioner?
Every auto air conditioning system has two service ports: one on the high pressure and one on the low pressure side. When recharging with AC Avalanche refrigerant, for safety, you will charge through the low side service port. Never charge through the high side port.
https://www.youtube.com/watch?v=L0900kIG26E