What fuse is for the interior lights?
Registered. It is Fuse #29 or #30. If it is not blown when you check it, disconnect the battery for 20 mins and then connect it.
How do you remove a dome ceiling light?
- Step 1 Light Bulbs & Rewiring.
- Twist the locking nut left to take it off.
- Pull the light cover down from the ceiling.
- Twist the light bulb out of it’s socket.
- Lift the heat cover, also known as foil, out of the way.
- Unscrew the screws halfway.
- There are three different colored wires.
How to reset check engine light in Toyota Camry?
Figure 1. Locate the fuse box near the steering column on the driver’s side. Check the diagram on the inside of the fuse cover to locate the ECU fuse. Pull the fuse labeled for the ECU. Figure 2. Pull the fuse designated for the ECU. Turn the ignition to the ON position only, but don’t turn over the engine. Wait for a few minutes.
How do you replace the dome light on a Toyota Camry?
Push the plastic cover closed. It’s recommended that you continue on to your remaining lights, so your entire Camry is well lit. Remove each cover as you did in the previous steps, and then detach and replace the old light (s). Close each cover once you are done. Figure 5. Once the cover closes, you are done!
Is there a way to reset the Check Engine light?
Regardless, here’s the quick and easy way to reset the CEL that is currently plaguing your dash. This article applies to the Toyota Camry (1997-2001). If you see the check engine light but your car is otherwise acting normally, chances are the check engine light is reporting something relatively minor.
What to do if your dome light is not working?
If a dome light is not working due to a blown fuse in your fuse box, you will need to pop the hood of your car and change out the old fuse using a pair of fuse pullers. Once the new fuse is installed, your new dome light (s) should shine brightly for you and your passengers to see clearly inside your Camry.