Where is the fuel pump relay located?
Location. Most fuel-pump relay units are located under the dashboard near the steering column. In some cases, the unit is located in the area where the steering column is mounted or near the engine’s firewall.
Where is the fuel pump relay on a 2012 Toyota Camry?
The 2012 Toyota Camry fuel pump relay location is inside the gas tank.
Where is the fuel pump relay on a 2006 Toyota Camry?
There is another relay in the fuel pump circuit; although, it’s harder to reach. This relay is known as the circuit opening relay. It’s located on top of the E.C.U. between the driver and passenger foot well behind the radio.
Where is the fuel pump relay on a 1994 Toyota Camry?
The fuel pump is controlled by the “Circuit Opening Relay” It is located under the Engine Electronic Control Unit (CPU) which is under the center of the dash.
Where is the fuel pump on a Toyota Camry?
It is located under the rear passenger seats in the fuel tank. The seats will need to be removed in order to get to the pump. The pump is easy to reach after the seats have been removed. It is a modular unit that may only need a pump replacement rather than the entire unit.
Where is the fuel pump relay on a 93 Toyota Camry?
Power to the fuel pump on your 1993 Toyota Camry is supplied by the “Circuit Opening Relay” located on the relay block above the glove box.
Where is the fuel pump relay on a 08 Toyota Camry?
The 2008 Toyota Camry’s fuel pump relay should be found under the engine bay’s main fuse box. It can be accessed by unbolting a 10 mm fastener from the fender wall and electrical box. It is called the “c/opn relay” and is plugged next to the Camry’s “efi relay”.
Where is the fuel pump relay on a Toyota?
The relay you are talking about is called the “Circuit Opening Relay” and is located on top of the ECU, which is between the driver and passenger footwell behind the radio. You can get to it by pulling back the front inner corner of the passenger carpet.
How can I tell if my fuel pump is working?
You can also apply power to the fuel pump to check that it is working. You will hear fuel flowing and a whine from the pump. When you put jumper between Fp and B+, you bypassed the fuel pump relay, so even if the circuit opening relay is bad the pump should work.
How do I get power to my fuel pump?
1. Remove battery pack from the drill and identify polarity on its connections (using cheap analog voltmeter) 3. attach drill (without battery) to the wires that supply power to the pump. With ignition on and jumper between the Fp and B+ depress the trigger on the drill.
When to connect the B + Terminal to the fuel pump?
The B+ terminal in the diagnostic connector should only have power when the key is in the ‘On’ position. Also, the fuel pump will only receive power (when B+ and Fp are not connected) when the key is in the Start position or the AFM flapper door is open (air is flowing into the engine).