Where is the starter relay located on a 2002 Toyota Camry?
The 2002 Camry houses its starter fuse within the engine compartment. Specifically, it can be found towards the left hand side of the engine compartment.
How do you test a starter cut relay?
Set your multimeter to be on the Ohms scale. Place one probe on the lead on the ignition circuit terminal and the other on the ground lead. The reading should be less than 5 Ohms. If it’s more than that, the starter relay is faulty and needs to be replaced.
Do cars have a starter fuse?
Often there is a fuse and relay for the car starter in the fuse box but sometimes they will have external fuse on the fuse line or close to the car battery. The starter motor fuse is usually big and it will not be in the fuse box. Check Your Fuses: Only a few cars have a fuse associated with the starting system.
How do you know if starter relay is bad?
How To Tell If Starter Relay Is Bad?
- The Vehicle Is Dead. The most obvious symptom is a completely silent car that does not respond when you turn the ignition key.
- Starter Making Clicking Sounds.
- Occasional Failures In Starting The Vehicle.
- Starter Does Not Get Switched Off.
How do you check for a faulty relay?
The only tool required to check a relay is a multimeter. With the relay removed from the fuse box, the multimeter set to measure DC voltage and the switch in the cab activated, first check to see if there are 12 volts at the 85 position in the fuse box where the relay plugs in (or wherever the relay is located).
Where does the current go in a relay?
Pin 87 is where high-amperage current from the battery enters the relay. Pin 30 is where that current flow from the battery goes out to the component when the electromagnet is energized and the circuit closed. The only tool required to check a relay is a multimeter.
Can a fuse be replaced on a relay?
Doing this is also an efficient way to make an emergency repair that will allow you to get the machine back to the yard until the relay can be replaced. Remember, a relay is not a fuse; there will still be a fuse to protect the circuit.
How can you tell if a relay has a blown fuse?
If voltage is able to flow through that side of the relay, move on to the 87 connection point and determine if battery voltage is present there. If it isn’t, that also suggests a blown fuse or circuit breaker. Checking the connection points in the fuse box with a multimeter will confirm if battery voltage is available at the relay terminals.