How do I change a kickdown cable?
Method 1 of 1: Replacing the kickdown cable
- Materials Needed.
- Step 1: Jack up the front of the vehicle and set the jack stands.
- Step 2: Place wheel chocks on the rear wheels.
- Step 3: Disconnect the kickdown cable at the carburetor or throttle body.
- Step 4: Remove the kickdown cable from the mounting bracket.
How do I know if my kickdown cable is bad?
Symptoms of a Bad or Failing Kickdown Cable
- The transmission shifts hard. An automatic transmission has multiple parts that are engineered to produce a smooth transition from one gear to another.
- The car shifts early and fast.
- The transmission shifts slow and late.
Where is the kickdown cable located?
The kick down cable is mounted to the carburetor, or, in the case of fuel injected vehicles, the throttle body. It runs from the butterfly arm on the carburetor down to the side of the transmission, where it attaches to an arm that allows the transmission to shift gears.
Can I drive without a kickdown cable?
A TH350 has a kickdown cable. On a transmission, you cannot run with it disconnected. A TV cable combines the functions of the vacuum modulator and the kickdown cable.
How much does it cost to replace a kickdown cable?
The average cost for automatic trans shift cable replacement is between $291 and $335. Labor costs are estimated between $165 and $209 while parts are priced at $126. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
Is a kickdown cable necessary?
In fact, if you don’t mind downshifting manually with the shift lever when passing, there’s really no need for a functional kickdown cable or switch at all. You must install a true TV cable with the correct throttle-lever pivot geometry and then adjust it properly or you will burn up the trans!
What does a kickdown switch do?
Automatic transmissions kick down to a lower gear to make use of the greater power delivered at the engine’s higher rpm; this typically occurs when the driver attempts to accelerate from a constant speed, as if to pass. …
Does a Turbo 350 transmission need a kickdown cable?
On a 350, it’s just a kick down cable, no problems. One an 700R4, it’s a throttle position cable and if it’s not hooked up it will burn up the transmission.
How long does it take to change a shift cable?
2) How long does it take to replace a shifter cable? Every vehicle is different, of course, but an average time to replace a shift cable is about an hour and a half.
What is a kickdown used for?
Kick-down is used when maximum acceleration is needed, such as for overtaking. When the accelerator pedal is pressed all the way to the floor (beyond the position normally regarded as full acceleration) a lower gear is immediately engaged. This is known as kick-down.