What is the rear center brake light called?
In North America, since 1986, all vehicles feature a third brake light. Legally, this is called the Center High Mount Stop Lamp, CHMSL for short, but informally called center brake lamp, high-level or eye-level brake lamp, cyclops brake light, or safety brake lamp.
How do you change a brake light on a 1998 Toyota Camry?
Remove the taillight assembly by grasping it on both side and pulling it straight out of the body far enough to access the bulb socket on the backside. Grasp the bulb socket and turn it counterclockwise then pull it straight out of the rear of the taillight housing. Pull the 3157 bulb from the socket and discard it.
What is the center brake light?
The third brake light, as it is commonly called, is a brake light that sits high above a vehicle’s taillights. Designed to sit in the line of sight of drivers following a vehicle, the high brake light is intended to serve as a warning that a vehicle is slowing down.
Is the center brake light required?
The law says that all passenger vehicles manufactured after 1986 (there was likely a phase-in based on vehicle type) must be manufactured with a third, center-mounted brake light. To pass state inspection, all factory lights must be functional.
What does rear light failure mean?
(j) Rear Light Failure Warning Light If this light comes on when the headlight switch is turned on (at the first or second clickstop), it indicates that one or more of the tail lights are burned out. If it comes on when the brake pedal is depressed, one or more stop lights are burned out.
Do you need a 3rd brake light?
Federal law mandates that all vehicles have the third brake light outfitted within the car. Additionally, the third light must be comparable to the other brake lights on the vehicle so that it is not distracting to the drivers behind the vehicle.
How to replace the bulb in a third brake light?
How to Replace the Bulb in a Third Brake Light Step 1. Locate your car’s third brake light housing, which may be accessed from the rear package shelf below the rear… Step 2. Remove the holding screws from the brake-light housing with a Philips screwdriver in a counterclockwise… Step 3. Pull the
How do you remove a brake light from a car?
Use a flat-blade screwdriver to pry the housing up to release the holding clips if there are no visible screws on your housing. Pull the third brake-light housing slightly away from its mounting surface. Rotate the light bulb socket in a counterclockwise direction and pull it straight from the housing. Pull the bulb from the socket and discard it.
How do you change the light bulb in a car?
Pull the lamp housing straight out from the rear of the cab. Twist the bulb socket at the rear of the housing in a counterclockwise direction and pull it straight out of the housing. Pull the bulb from the socket and insert a new bulb. Replace the lamp housing in the reverse order.
Is there a YouTube error with my brake light?
An error occurred. Please try again later. (Playback ID: G9lWSldIzFbheFmU) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.