Why is my Camry not starting when I put the key in?
While there are a variety of reasons your Toyota Camry won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
Where is the starter relay on 2002 Toyota Camry?
The 2002 Camry houses its starter fuse within the engine compartment. Specifically, it can be found towards the left hand side of the engine compartment.
What is a starter relay fuse?
A starter relay is an ignition system component specially designed to transmit power from the car battery to the starter solenoid. This implies it is a switch between the starter solenoid and the starter motor. It is solely designed to transmit current from the car battery to the starter properly.
What does it mean when your Camry won’t start?
The first and most common is when it won’t turn over. This just means that the engine doesn’t move when you turn the key. The second way that your Camry won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own.
Why does my Toyota Prius not start up?
If you get no lights and your battery is working, the ignition switch could be to blame. If you get dash lights, then turn the key to start to see if the lights go out on the dash. If the lights go out, your ignition switch is okay. Starter Connection – Corrosion on the starter can keep the car from starting.
Why does my car make a clicking noise when I start it?
I own a 2012 Camry se. Recently I tried to start my car and get this rapid clicking noise with a failure to start. I know NOTHING about cars and really need help fixing this problem.. I own a 2012 Camry se. Recently I tried to start my car and get this rapid clicking noise with a failure to start.
What to do if your Toyota won’t start?
Battery – If the connections on your battery become corroded, there is no longer a connection to the rest of the car. This can keep you from starting. Clean the posts and try to start the car. Additionally, the battery may be dead. Take a battery tester and test the cranking amps to see if they are weak.