How do you remove a Mitsubishi radio?
Unscrew the radio from the dashboard using the Phillips-head screwdriver. The screws are located at the very back of the deck, behind where the climate controls were located. Pull the radio out of the dashboard and unplug the stereo harness on the backside, as well as the antenna lead.
How do you get a radio cover off?
Pry the dashboard covering off if you have a newer car. Find the edge of the panel and insert a plastic prybar into the space. Work the prybar around the panel until it pops off, then pull it off to reveal the stereo.
How do I reset my Mitsubishi Outlander radio?
To reset the Bluetooth in the Mitsubishi Outlander, turn the ignition to the ON spot, which is achieved by pressing the on / off button twice without your foot on the trigger, and then try a single click. Click and hold down the “hang-up” button for 2 seconds. Release the button and repeat it 2 times.
How do you use radio removal tool?
Simply insert the proper tool and wait for the “notch” feel. Once you feel the notch, apply force away from the radio towards the rear of the vehicle to remove the radio from the dash.
How do you replace a stereo in a Toyota 4Runner?
Pull the stereo from the console. Disconnect the electrical connectors from the back of the unit and remove the stereo. Figure 4. Pull the old unit from the console. Depending on the replacement stereo unit you have purchased, it may require wiring adapters.
How do you remove a radio from a car?
Grab the base of the radio surround panel directly in front of the gear shift knob. Pull the panel until the clips are released. Carefully pull back the panel to expose the rear. Disconnect the three wiring harness connections on the rear of the panel. Set the panel aside. Remove the four mounting screws around the radio.
How do you remove the dash from a Toyota 4Runner?
Use a trim panel tool to pry up the edges of the panel and remove it. Figure 1. Pull off the center shift console panel. Earlier 3rd generation models require the removal of the climate control panel before you can remove the dash panel. Remove any control knobs, pry off the face plate and remove the screws below.
How do you hook up a new radio to a old radio?
Set the panel aside. Remove the four mounting screws around the radio. Carefully pull the radio out and disconnect the wiring harness and the antenna cable. Attach the factory wiring harness and antenna cable to the new radio.