Where is the oil filter located on a 2011 Toyota 4Runner?
The 2011 Toyota 4Runneroil filter is found near the bottom or the middle of the engine. The recommended oil type for the 4Runner is the SAE 0W-20 which ensures a smooth experience and overall performance if changed regularly.
What kind of oil does a 2011 Toyota 4Runner use?
Engine Oil 0W-20 is the best choice for good fuel economy and starting in cold weather. If 0W-20 is not available 5W-20 may be used. However, it must be replaced with 0W-20 at the next oil change.
How do you change the oil on a 2010 Toyota 4Runner?
HOW TO CHANGE YOUR OIL – STEP BY STEP
- Step 1 – Good Location.
- Step 2 – Grab some Latex Gloves.
- Step 3 – Remove Skid Plate Cover.
- Step 4 – Remove the oil drain plug.
- Step 5 – Remove the Front Skid Plate & Cover.
- Step 6 – Remove the Oil Filter.
- Step 7 – New O-ring from the filter box.
- Step 8 – Screw the filter assembly back in.
How much oil do you put in a Toyota 4Runner?
Replace the oil filler cap, run the engine for a minute, let it sit for a few minutes, and check the level on the dipstick. Add more oil until the level on the dipstick reaches the upper “Full” mark. The 1GR-FE 4.0L V6 engine officially requires 5.5 US quarts for an oil change with a new filter.
Where is the oil drain on a Toyota 4Runner?
The oil drain bolt is located near the rear of the engine and can be seen through the oval access hole in the engine’s metal skid plate. Place some newspapers or rags under the oil drain bolt and position the used oil catch container under the oil drain bolt.
What can I do with a Toyota oil change?
Do more yourself – Do it Yourself Home Improvement – Plumbing / Heating / Generators / Landscaping & Gardening – Lawn Care Everything you see is how I take care of my home and I hope that you can use some of my videos to help you do more yourself at your home. Clean & Detail Your Car Engine in 5 Minutes!
How do you tighten a new oil filter?
Twist on the new oil filter and tighten it down by hand to about 1/4 to 1/3 turn past hand tight. Then re-attach the oil drain bolt with the 14mm socket and tighten it about 1/4 to 1/2 turn past hand tight. Don’t over-tighten the oil drain bolt to avoid damaging the threads or oil pan.