Where is the alternator fusible link?
They are placed in-line between delicate harnesses and large sources of electrical current in your car—between the battery and alternator, for example. These links must transmit high-current electricity, but also protect the rest of the electrical system from dangerous spikes that could cause a fire.
Can I replace a fusible link with an inline fuse?
A fuse will not work, you must replace with a fusible link. A fusible link is a solid wire (but smaller awg) placed in a current carrying line where there should NEVER be a dead short.
Does the length of a fusible link matter?
According to this Fusible link FAQ: What size replacement fusible link should be used ? The automotive service industry recommends using the same gauge and length as the blown fusible link after the cause of failure is corrected. Ensure the size/length you put back in is the size/length you took out.
Where is the alt’s fuse on a Toyota?
The “ALT-S” fuse is the charging system fuse. Step 6 Locate the fuse removal tool within the fuse box. The fuse removal tool is a plastic set of tweezers held in place with a plastic clip.
How do you remove a fuse from a Toyota alternator?
Locate the fuse removal tool within the fuse box. The fuse removal tool is a plastic set of tweezers held in place with a plastic clip. Pull the fuse removal tool off the plastic clip to remove it. Grasp the top of the “ALT-S” fuse with the fuse removal tool and pull directly up to remove it from the socket.
Where is the Charger fuse on a Toyota?
Lift the tab on the cover of the fuse box and remove the cover. Locate the fuse labeled “ALT-S” on the fuse diagram. The fuse diagram is a sticker, usually located on the top or bottom of the fuse box cover, which shows the location of each fuse within the fuse box. The “ALT-S” fuse is the charging system fuse.
How do you connect a fusible link to a car?
Check the fusible link. A fusible link is just like any other car fuse, but instead of being plastic, it is a thin wire with a thick insulator. To properly connect a fusible link you need to use a crimp, solder, and shrink-wrap the connection. Soldering Iron that is really good: http://www.amazon.com/gp/product/B002…