How to remove rear drum brake rotors in Toyota?
Make sure the parking brake is OFF, put wheel chocks behind the front tires and jack up the car, put it on a stand and then remove the right back tire. 2. Remove right drum brake rotor: 3. Spray brakes with brake parts cleaner (make sure you don’t inhale any brake dust) 4. Remove the small return spring using the hook tool: 5.
What to use to clean brake rotors on Toyota Camry?
Spray the rotor with brake cleaner or wipe down with a degreasing solvent, such as acetone. With the hub and rotor clean, slide the brake rotor into place. For the rear rotor, be sure the parking brake adjusting hole in the rotor hat aligns with the hole in the hub.
How much does it cost to replace brake pads on a Toyota Camry?
Here is the breakdown of the DIY Cost: 1 Front brake pads: $15-35 2 Rear brake pads: $15-35 3 Front brake rotors: $32-70 4 Rear brake rotors: $35-70 5 Front brake caliper: $45-85 6 Rear brake caliper: $40-85 7 Caliper hardware kit: $10-15
How do you clean a new brake rotor?
A new brake rotor will typically come coated in a light film of oil to prevent rusting. This oil must be removed prior to installation. Spray the rotor with brake cleaner or wipe down with a degreasing solvent, such as acetone. With the hub and rotor clean, slide the brake rotor into place.
How big is the rear brake drum on a Toyota Corolla?
Using a brake drum gauge or equivalent, measure the inside diameter of the drum. Standard inside diameter: 200.0 Mm (7.874 In.) Maximum inside diameter: 201.0 Mm (7.913 In.) 5. Remove rear brake automatic adjust lever lh Using a needle–nose pliers, remove the upper side tension spring.
What to do if you have a brake problem in your Toyota Corolla?
1. Remove rear wheel 2. Drain brake fluid : wash the brake fluid off immediately if it comes into contact with any painted surface. 3. Remove rear brake drum sub–assy Release the parking brake lever, and remove the brake drum. : if the brake drum cannot be removed easily, do the following steps.
How big is a rear drum brake shoe?
Inspect rear drum brake shoe lining thickness Using a ruler, measure the thickness of the shoe lining. Standard thickness: 4.4 Mm (0.173 In.) Minimum thickness: 1.0 Mm (0.039 In.)