How do you take the back seat out of a 2003 Honda CRV?

How do you take the back seat out of a 2003 Honda CRV?

How to Take the Back Seats Out of a Honda CRV

1. Move both front seats as far forward as possible.
2. Open one of the back passenger doors and climb in to the CRV.
3. Tilt the seat forward and remove the retaining bolts with a socket wrench.
4. Pull the seat forward and away from the bolts.

How do you remove the center console on a Honda CRV?

Rear Console

1. Slide both of the car’s front seats forward.
2. Push the seats all the way back—you will likely need to use the lever for this.
3. Lift the console up at the rear end and tilt it toward the rear to disconnect the console.
4. Insert the replacement console in place, positioning the rear end first.

How do you take the back seat out of a 2002 Honda CRV?

How do i remove the rear seats in a honda cr-v 2002

1. Remove the lower hinge covers, then remove the bolts.
2. Fold the seat cushion forward, and remove the base frame cover, then remove the bolts and nut.
3. Remove the headrest.
4. Carefully remove the rear seat through the door opening.

How do you take the back seat out of a Honda CRV?

Locate all the retaining bolts holding the CRV’s rear seat to the floor. Tilt the seat forward and remove the retaining bolts with a socket wrench. Pull the seat forward and away from the bolts. Climb out of the CRV and pull the seat out through the open door. Be careful not to scratch the car while you’re pulling the seat out.

How do you lower the head restraints on a Honda CRV?

To raise it, pull upward. To lower the restraint, push the release button sideways, and push the restraint down. To pivot the outer head restraint down for better visibility, press the tilt button on the side of the head restraint. It folds down forward.

How do you remove a transmission from a Honda CRV?

The best way to remove the electrical connectors is NOT to break the tabs on them with a screw driver. Instead, use your meaty hands to squeeze the tab until it clicks, then stick a flatblade screwdriver between the two connectors and twist. Most of the connectors will be pretty seized up.

What is the part number on a Honda CRV?

The Honda part number is 18393-SH3-S00. The nuts are probably too rusty to work with, so replacing them is not a bad idea. They are part number 90212-SA5-003. Disconnect the two electrical connections of the exhaust, then remove the bracket holding them on.

How do you remove the seats from a Honda CRV?

It’s actually quite simple to remove the seats and the only tools you will need are a flat head screwdriver and a ratchet with a 12mm socket. Follow the video’s instructions and you will be able to remove the rear seats in about 10-15 minutes. Loading…

How do you get the rear differential off a Honda CRV?

– The INSULATORS that are pressed in to the differential mounting plate (the plate that holds the differential to the body) These insulators are stuck really hard- You will have to pry them out using a screw driver and a hammer to raise the lip and a pry bar to pry the lip up until the insulators fall out.

Do you need to remove the mounting plate on a Honda CRV?

You do not need to remove the shafts to change the mounts, you only have to lower the differential enough to remove the mounting plate from the top of the differential. Then you can dissasemble the mounting unit and rubber cushions. NOTE!!! This is very important!

To raise it, pull upward. To lower the restraint, push the release button sideways, and push the restraint down. To pivot the outer head restraint down for better visibility, press the tilt button on the side of the head restraint. It folds down forward.