How do you reset the timing belt light on a 105 series Landcruiser?
the reset procedure of the timing belt light is all done by pressing the trip meter button and holding it in whilst the ignition is turned to on then select from the trip button then continue pressing until you come to 15 on trip metre, turn off and then restart. The light should then go off.
How do you reset the timing belt on a 2kd?
Press and hold the odometer/trip display button whilst turning ignition on. Hold button down for 5 seconds then release button. Within 5 seconds, press and release the button. The display will show the reset value.
How do you turn off the belt light on a Toyota Land Cruiser?
Follow the instructions below to reset the T-Belt Light on your Toyota Land Cruiser J200:
- Turn the ignition key to the “ON” position without starting the engine.
- Press the ODOMETER/TRIP button repeatedly until you see “ODO”
- Next, turn the ignition “OFF”
How do you turn off the timing belt light on a 80 series Landcruiser?
In your instument cluster there is reset button. There is a rubber plug that you will need to pull out. The reset button is behind it. It should be right next to the trip odometer reset.
How to reset your Landcruiser timing belt dash light?
Quick how to guide on resetting your timing belt dash light if you want to change the interval of the timing belt service when it displays “15” you can cycle through from 1 to 15 (10k – 150k) buy pressing the button. Once correct number is shown hold for 5 seconds and release. Loading…
How to reset the timing belt warning indicator?
Timing Belt Warning Indicator Reset Procedure. For LandCruiser UZJ100, HZJ105 and HDJ100. a) With ignition turned ON, using the trip switch (select/reset button) change the display to ODO, and turn the ignition OFF. b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds.
How do you change the timing belt on an 80sr?
Refit the cover (dont be tempted to leave out the bottom bolt) and the p/steer res. and your good as done. On an 80srs, reset the light on the dash by pushing the reset button in the speedo with a scriber or similar. On a 79 or 100, you hold in the odometer button while tuning on the ignition, then hold for 5 seconds.
How do you change the distance on a T Belt?
While in the T-Belt mode, each press of the trip switch will change the displayed value by 10,000km increments. Once ” 20 ” (200,000km) is reached the display reverts back to ” 1 ” (10,000km) again. Remember, this setting is the number of kilometres to be travelled before the light comes on next, and once reset this counter will start from zero.