What does p1259 stand for in immobilizer code?
There are no codes directly related to P1259. Any problem such as abnormal input or system voltages, intermittent faults, or high resistances in any part of the immobilizer control circuit will set code P1259. Below are some examples of definitions of code P1259 that do not relate to the anti-theft system.
Where is the VTEC system malfunction code p1259?
Re: VTEC System Malfunction code P1259 has appeared. (… Check your variable valve timing oil pressure switch, it’s located on the passanger side just before the intake manifold, also the solenoid may be dirty or bad. some people say to clean the screen but that requires removing the entire assembly where these two units are… Good luck
What causes a PCM signal error code p1259?
The most common cause of code P1259 is flat batteries in keys, with abnormal system voltages caused by faults and defects in the charging system that could damage control modules following close behind.
When to set code p1259 in Powertrain Control Module?
On applications that use this definition, code P1259 is set when a break in communication between the immobilizer module and the PCM (Powertrain Control Module), or between the transponder key and immobilizer module occurs.
There are no codes directly related to P1259. Any problem such as abnormal input or system voltages, intermittent faults, or high resistances in any part of the immobilizer control circuit will set code P1259. Below are some examples of definitions of code P1259 that do not relate to the anti-theft system.
What is the OBD II fault code p1259?
END OF SPECIAL NOTES. OBD II fault code P1259 is manufacturer-specific code that some manufacturers define as “Immobilizer to PCM Signal Error”.
The most common cause of code P1259 is flat batteries in keys, with abnormal system voltages caused by faults and defects in the charging system that could damage control modules following close behind.
On applications that use this definition, code P1259 is set when a break in communication between the immobilizer module and the PCM (Powertrain Control Module), or between the transponder key and immobilizer module occurs.