Menu

Navigation

How do you fix trouble code P0122?

Posted on by Arif Clayton

How do you fix trouble code P0122?

What repairs can fix the P0122 code?

  1. Repairing or replacing the TPS connector.
  2. Repairing the wiring as necessary.
  3. Replacing the TPS with a new sensor.

What are the symptoms of a bad accelerator pedal sensor?

SYMPTOMS OF A FAULTY ACCELERATOR PEDAL SENSOR: SYMPTOMS

  • Increased engine idling speed.
  • Vehicle does not respond if the accelerator pedal is pressed.
  • Vehicle switches to “limp-home mode”
  • Engine warning light in the cockpit illuminates.

    How do you know if your throttle positioning sensor is bad?

    What Are The Symptoms and Signs Of a Failing Throttle Position Sensor?

    1. Lack Of Power. If your engine isn’t getting the fuel it needs, or is getting too much, you’ll notice that it doesn’t seem to be accelerating as it should be.
    2. Trouble Accelerating.
    3. Uneven Idle.
    4. Check Engine Light.

    Can you read the fault code on a Subaru Outback?

    Subaru’s on the other hand have 2 modes. You can read the stored fault codes or you can check them while the car is driven. This is useful if you have a fault code that only appears when you drive and doesn’t hang about long enough to be stored.

    Where do you find the trouble code on a Subaru Justy?

    The long segment (1.2 sec on) indicates a “ten”, and the short segment (0.2 sec on) signifies a “one”. 90 models – Trouble codes on the Justy are viewed on the Oxygen Moniter light, all other models the codes can be viewed on either the Oxygen Moniter light or the MIL (check engine light).

    How do you reset the Check Engine light on a Subaru Outback?

    Then try to slide the cable off the negative battery terminal. You now have to wait 4 to 5 minutes, before your then reconnect the cable and tighten the retaining nut. Finally, start the car engine and wait for the vehicle Subaru’s computer to reset the check engine light.

    How to find fault code on Subaru Impreza?

    Count the flashes on the management light. Remember a long flash is 10 and a quick flash is 1. Compare the code to the list above. Turn the ignition off and disconnect the green connectors. That’s you!