Can you have LED blinkers?
LED turn signals for motorcycles can provide anywhere from 20,000 hours to 40,000 hours of light. And fortunately, if your bike isn’t already equipped with LED turn signals, it’s very easy to install them yourself. You can swap out your incandescent turn lights for LED options at an affordable price.
How to fix a blinker on a turn signal?
1 Turn the key to the “ON” position, and push the turn signal switch in the direction the system blinks fast in, right or left. 2 Inspect both the front and rear of the vehicle to identify the directional signal bulb failure. 3 Disassemble to replace the non working bulb with new, recheck the operation of the blinker system before reassembly.
Can a blinker be used as a running light?
Most aftermarket LED blinkers support only a two wire connection, which means they can only be used as either a running light, or a blinker light. The Blinker Genie solves this problem, and intelligently controls the lamp to function as BOTH a running light and a blinker!
Why is my blinker Genie not working properly?
The reason is because the running light wire that runs to the front signals cuts off completely when the blinkers are activated, and stays off until the blinkers are canceled. This causes the operated load (LEDs or lamps) to not work properly as the Blinker Genie is designed to draw all power from the “running light” input wire.
Where are the LED blinkers on my bike?
On the rear of my customs the Indicator wiring will run into the electrics tray where it will link to the flasher relay or on my bikes, the black box control module. The black box module will control LED blinkers and normal incandescent (bulb type) blinkers without any need for resistors or relays.
On the rear of my customs the Indicator wiring will run into the electrics tray where it will link to the flasher relay or on my bikes, the black box control module. The black box module will control LED blinkers and normal incandescent (bulb type) blinkers without any need for resistors or relays.
What should I do if my blinker is not working?
The first and easiest way to correct the issue is to change the signal flasher relay to an electronic type signal flasher relay. These electronic units replace the thermal design with a relay that detects a much lower load and begins and “electronic” cycle of open and closed circuit to create the blink rate.
Why does my LED flasher Blink so fast?
Hyperflashing is when the turn signals blink faster than your stock incandescent bulbs did. This happens because your new LED bulbs draw such little power that your turn signal relay sees the bulbs as being out. Installing an LED flasher module specifically designed for LED bulbs.
Can a black box control a led blinker?
The black box module will control LED blinkers and normal incandescent (bulb type) blinkers without any need for resistors or relays. The front will be neatly wired to a connection either behind the headlight or under the gas tank