Where is the cam angle sensor located?
The Camshaft Position Sensor detects camshaft rotation, and is mounted near the cylinder head so that the sensor is opposite to the timing rotor attached to the engine camshaft. The engine ECU detects the camshaft angle, and performs cylinder recognition based on the signals detected by the camshaft position sensor.
How do I fix error code P0340?
What repairs can fix the P0340 code?
- Repairing or replacing the camshaft position sensor circuit wiring.
- Repairing or replacing the camshaft position sensor circuit connector.
- Replacing the camshaft position sensor.
- Replacing crankshaft position sensor.
Will a bad camshaft sensor throw a code?
Answer: Usually a camshaft sensor intermittent failure can produce no code. But you’ll notice a change in driveability performance at times. Sometimes it’s possible to detect the failure with a scan tool.
Can you drive with a faulty cam sensor?
Yes, it is safe to drive with a bad camshaft sensor. However, the performance of your engine will not be as good and fuel consumption may increase. If you have any trouble with your camshaft sensor, there are a few ways to test and diagnose the problem.
What causes a cam sensor to go bad?
Over time, the camshaft position sensor can fail, or become worn down, due to accidents or normal wear and tear. There are a few warning signs to watch out for before your camshaft position sensor completely fails and shuts down the engine, making replacement a necessity.
What does code P0340?
What Does P0340 Mean? The camshaft position sensor located in the internal combustion engine monitors the position and rotational speed of the camshaft. When the trouble code P0340 is set, the ignition spark and fuel injector timing fails due to the engine not knowing when to fire these components.
What causes a p0340 Subaru camshaft position sensor code?
Sometimes and in some models, low battery voltage or a weak starter can trigger a Camshaft Position Sensor code. The cost of diagnosing the P0340 SUBARU code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
What does the camshaft position sensor do in a Subaru?
P0340 Subaru Description The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module(ECM) to control ignition and fuel injection.
How much does it cost to repair a Subaru p0340 code?
The cost of diagnosing the P0340 SUBARU code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P0340 SUBARU code detected?
Are there any DTCs associated with the p0340 sensor?
Double check these before coming back to the CMP. DTC P0340 or P0345 may be accompanied by other DTCs, such as P0300 Random Misfire, P0725 Engine Speed Sensor Circuit, or P0335 Crankshaft Position Sensor Circuit Malfunction.