How do you reset the tire pressure sensor on a Suzuki sx4?
Insert the end of the compressed air nozzle into the valve stem of each tire that is below 33 psi. Allow the air to enter the tire for a few seconds at a time. Check the pressure again after each burst of air. Stop when the reading is 33 psi.
What happens if a tire pressure sensor goes bad?
The batteries inside these pressure sensors generally last around 5-7 years, so it’s not uncommon for tire pressure sensors to fail several times within a vehicle’s life. This can result in valve stems breaking off or cracking, causing the tire to go flat.
How do I know if my tire pressure sensor is bad?
A small light illuminates at the dashboard’s display panel whenever there is a problem with the tire pressure sensors. It appears as a vivid yellow exclamation point inside of a U symbol; you’d be easily able to spot it. As soon as it turns on, the driver must check the tire for less or no air.
How do you fix malfunction in tire pressure warning system?
Without starting the car, turn the key to the “On” position. Press the TPMS reset button and hold it until the light blinks three times, then release it. Start the car and let it run for 20 minutes to reset the sensor. You’ll usually find the tire pressure monitor reset button beneath the steering wheel.
How much does it cost to replace a tire pressure sensor?
Generally speaking, the TPMS sensor replacement cost is going to fall somewhere between $230 and $750 in most cases. And unlike some other auto repairs, it’s the parts, not the labor, that are going to get you. TPMS sensors can cost anywhere from $180 to $680 alone.
What is a TPMS reset button?
TPMS stands for Tire Pressure Monitoring System. In most vehicles the TPMS reset button is found beneath the steering wheel. After changing the tires on your vehicle, the TPMS needs to be electronically reset in order to clear the error code. Start your vehicle and wait 20 minutes and the sensor will refresh.
How to reset the tire pressure sensor on a Suzuki?
Release driver side door switch and then press driver door switch for 2 seconds or more by hand. Release driver side door switch and then press driver side door switch for 2 to 5 seconds by hand. Using special tool (09945-86510), activate each tire pressure sensor within 90 seconds.
How to reset the Suzuki TPMS ignition switch?
Press driver side door switch hand within 5 seconds after the ignition switch turned ON. Keep the switch pressed for 2 seconds. Release driver side door switch and then press driver door switch for 2 seconds or more by hand. Release driver side door switch and then press driver side door switch for 2 to 5 seconds by hand.
When to replace a faulty tire pressure sensor?
When tire pressure sensor is activated, flashing LED and beeping sound of special tool indicate an activation of the tire pressure sensor. In case that LED does not flash and beeping sound is not heard even if special tool is normal, replace faulty tire pressure sensor.
When does the tire pressure sensor activate TPMS?
When the tire pressure sensor is activated, the ID code of the tire pressure sensor is registered automatically in the TPMS control module. If each ID code of 4 tire pressure sensors is not registered in the TPMS control module within 90 seconds, start all over from Step 1).