Where is the throttle position sensor TPS mounted?
throttle body
The throttle position sensor is mounted onto the throttle body and measures the opening and closing movements of the throttle valve and these are transmitted to an engine control module, this information, as well as other measurements including; temperature, engine RPM and mass air flow (MAF), are used by the engine …
Where is the throttle position sensor on a 2006 Subaru Outback?
Are you looking for the throttle position sensor? On this model it uses an electronic throttle and the TPS is part of the whole throttle body and cannot be replaced. The sensor you have may be the pedal position sensor, this is mounted to the gas pedal up under the dash.
How do I know if my throttle position sensor is going bad?
- An unexplainable bucking and jerking in the vehicle.
- Sudden idle surges.
- Sudden engine stalling without any apparent reason.
- Hesitation while accelerating.
- Sudden surges in speed while driving on the highway.
- Intermittently flashing of check engine light for no apparent reason.
- Difficulties in changing gears.
How do you reset the accelerator pedal position sensor?
To recalibrate the ECM and accelerator pedal, the ignition switch must be in the ON position and then the accelerator pedal must be slowly and fully depressed from idle to full throttle. Repeat the procedure three times.
Where is the TPS sensor on a Subaru Legacy?
Location of Throttle Position Sensor (TPS) on 2006 Subaru Legacy. I have the replacement sensor but cannot find the location of it to replace it. I’ve looked on the throttle body but all I see is the MAP sensor connected to it, along with another harness connected to the throttle body itself. I have potentially two somewhat simple questions.
Where is the throttle position sensor on a 2006 Subaru?
By 06 all of them were fly by wire. If you look at the wiring to the pedal position sensor, you may find its been pulled or possibly kicked loose by mistake so make sure the connector and harness are good and tight. Also, as for the hard starting, this could be a result of this or a problem with the maf sensor.
Is the TPS part of the throttle body?
On this model it uses an electronic throttle and the TPS is part of the whole throttle body and cannot be replaced. The sensor you have may be the pedal position sensor, this is mounted to the gas pedal up under the dash. Please let me know what more I can do to assist you today.
What does code 31 on Subaru TPS mean?
After doing the “secret handshake” I determined I have a code 31 failure which means the throttle position sensor. Here is the procedure from Subaru to check the sensor for proper operation. After replacing my sensor the code is gone and the car operates great. Find the troubleshooting procedure online or go to your dealer (that’s what I did).