What does P1164 mean?
P1164 – Air/Fuel Ratio Sensor 1 Range/Performance Problem.
How do you reset the TCS light on a 2001 Honda Accord?
To reset the TCS light on the Honda Accord You will need to press down and hold the brake while turning off the car and then turning it back on. That said if the light comes back on then You have a problem with Your traction control system.
What was the error code on my Honda Accord?
I used to have both P1166 and P1167 error codes on my 2001 Honda Accord (F23A4 engine). I fixed the P1166 by replacing the O2 sensor. For about a day, everything looked wonderful (i.e. no check engine light on). Then, (after a day), the dreaded check engine light turned on again.
Why do I get fault code p1735 on my Honda Accord?
On Honda equipped with the four-cylinder engine, the problem could be due to the TCC lock-up solenoid. This may be the problem if you are getting fault code P1735.
What does the book say about p1166 and P1167?
The book says that both P1166 and p1167 is defined as the primary air/fuel sensor heater malfunction (not secondary). – shuva Nov 3 ’17 at 6:46 The Air/Fuel Ratio (A/F) sensor 1 is installed in the exhaust system and detects oxygen content in the exhaust gas. The A/F sensor transmits output voltage to the Engine Control Module (ECM).
What does P1167 stand for in EVAP code?
The heater element is on until the engine is at normal operating temp then it switched off. P1167 is the upstream O2 sensor just before the cat. If it is anything like a evap code where the computer has to relearn the sensors parameters under varying load conditions by doing tests etc.
What is the fault code for a Honda Accord?
P1297 Electric Load Detector (ELD) Circuit Low Voltage P1298 Electric Load Detector (ELD) Circuit High Voltage P1300 Random Misfire P1324 Knock Sensor Power Source Circuit Low Voltage P1336 Engine Speed (RPM) Fluctuation Sensor Intermittent Interruption P1337 Engine Speed (RPM) Fluctuation Sensor No Signal
What is the diagnostic code for a Honda check engine light?
Refer to our Generic OBD II code list for definitions on all other Honda diagnostic trouble codes. P1201 Cylinder 1 Misfire – Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0301
What is the DTC code on a Honda Accord?
MIL will indicate DTC’s by outputting a number of flashes. Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Honda diagnostic trouble codes. Manufacturer Specific Codes P1106BARO Circuit Range/Performance Malfunction P1107BARO Circuit Low Input P1108BARO Circuit High Input
What to do if your Honda code is not working?
A guide on how to check your codes: If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.