How long does it take to change a torque converter clutch solenoid?
Torque Converter Replacement Costs If you plan on fixing it yourself, then you’ll spend around $150 to $500. On the contrary, taking the vehicle to the transmission shop may require $600 to $1000 to cover the repair costs. It’ll also take about 5 to 10 hours to get the job done.
Why did Subaru extended CVT warranty?
Subaru Corporation is offering consumers an extended warranty on the continuously variable transmission (CVT) on approximately 1.5 million vehicles after concerns were raised about transmission problems that may cause the vehicle to stall on model year 2012-2017 vehicles. …
What is a valve body replacement?
The valve body is a part of all automatic transmissions that acts as the main control center of the system. When a failing valve body causes symptoms and/or failures like noise during gear shifts, slippage, delays, and difficulty reversing, a driver is left with no choice but to fix or replace the part.
What are the signs of a failing torque converter?
When the torque converter starts malfunctioning, you may feel shuddering and even slipping in overdrive. You usually notice your car shuddering because it feels like it’s vibrating. Your car will vibrate even when you’re not going very fast. The shuddering makes the car lag and is very noticeable.
What does the p2764 code in OBD-2 mean?
What the P2764 code means. The P2764 code is a standard OBD-II trouble code for the torque converter clutch pressure control solenoid circuit. The powertrain control module (PCM) uses the engine load and speed, as well as the vehicle speed and throttle position to select the needed torque converter clutch application (called “lock up”) degree.
When does the p2764 clutch pressure control code set?
When the Transmission Control Module (TCM) detects a continuous open or short to ground in the Torque Converter Clutch Pulse Width Modulated (TCC PWM) Solenoid valve circuit, then the P2764 code sets.
How much does it cost to repair p2764 code?
Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P2764 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
What does the p2764 code on a torque converter mean?
All our repairs are backed by our 12-month / 12,000-mile warranty. The P2764 trouble code signals a deviation in the torque converter clutch pressure control solenoid circuit deviating. The P2764 code is a standard OBD-II trouble code for the torque converter clutch pressure control solenoid circuit.