How do I know if my blower motor relay is bad?
Symptoms of a bad heater blower motor resistor
- Fan does not work at all, so no air comes out of the vents.
- Fan only works on some speeds and not others.
- Fan only works on the highest speed.
- Fan runs all the time and can’t be controlled with the fan switch.
- You see smoke coming out of the vents.
What causes blower motor to stop working?
In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. Start by checking the blower fuse and HVAC controller fuse.
Why does my blower motor only work on high?
Resistor module replacement Most car manufacturers use a series of resistors to make the heater blower motor run at different speeds. And when one or more of these resistors burn out, you’re usually left with only one heater blower motor speed—high. The resistor module is easy and inexpensive to replace.
What happens when a blower motor relay goes bad?
If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.
What happens when your blower motor resistor goes bad?
If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed. The heating and air conditioning systems may still function at one speed, however the resistor will have to be replaced in order for full functionality to be restored.
Will a blower motor work without the resistor?
What should I do if my blower motor is not working?
If it’s good, refer to a wiring diagram for your vehicle and conduct these tests: Disconnect the electrical connector at the blower motor and jumper power and ground to the motor, bypassing all the speeds controls.
Why is the resistor not working on my blower?
Hi There, The resistor is what controls the speed of the blower motor, not the relay. The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all.
How is the speed of the blower motor controlled?
The blower resistor is connected in series to the blower fan motor. This means that the current running through the blower motor, and its’ speed is therefore controlled by the resistor value. The user chooses a fan speed by selecting a speed which then connects one of the resistors in the blower resistor pack.
Why does my blower not work at high speeds?
Blower works on slow speeds, but not on high speed. Check for bad fuse or bad high speed relay. Swap the high speed relay with another relay with the same part number. Also, check the fuse for the control side of the high speed relay. Make sure the ground side of the high speed relay is working. Blower works on some speeds but not others