How do I reset my Subaru Impreza computer?
How to Reset a Subaru Check Engine Light
- Open the hood of your Subaru and loosen the nut that holds the cable clamp to the negative battery terminal.
- Slide the cable off the negative battery terminal.
- Wait 5 minutes, then reconnect the cable and tighten the retaining nut.
How do you reset the code on a Subaru Impreza?
How to clear the fault codes on your Subaru including Legacy’s and Impreza’s
- Turn the ignition off.
- Find the diagnostic connectors.
- Connect the black connectors together.
- Turn the ignition on but don’t start it.
- Check the engine management light comes on.
- Count the number of flashes.
How do I reset my 2011 WRX ECU?
To reset your ECU just disconnect your negative battery cable and just leave your door open to drain the power that might be in the system, do this for about 10 seconds and your done!
What causes a Subaru Impreza to not start?
When a starter goes bad, they will usually not give you much warning first. Also, if you are stuck somewhere and are trying to start your Impreza, the old beat the starter with a hammer trick is not a wives tale. It really can get that one last start out of it. There are a lot of issues that can cause your Impreza to crank, but not start.
How to disable the immobiliser on an Impreza?
Unlocked the car manually and tried to dis-engage the immobiliser with the key in the ignition but it wouldn’t work. To cut a long story short, the car is still alarmed (it goes off when you open the doors) and the immobiliser is still active. I’ve also tried to overide the alarm on the key pad inside the car (got the code from Subaru).
How do I disable the ignition on my Impreza?
Do they use their own to disable the ignition system thereby not requiring the ignition on, press the button on the alarm keyfob if you don’t start the car within 30s. I don’t quite understand. Pressing the button on the 213 unlocks the car, disarms the alarm and ‘mobilises’ the car.
How to re-activate the alarm on an Impreza?
Saying that though, on the right hand side of the wheel and down a bit, theres a pull out keypad. Your dealer should have a record of the 4 digit code that you enter to re-activate the alarm. Enter it once, and the alarm will start beeping. Enter it again, it will unlock, and you should be able to start the car. But most likely Alarm Ecu.