When to change timing belt on Subaru WRX?
Since changing the timing belt is somewhat of an involved process, it would be wise to replace those two parts at the same time since they’re easily accessable when everything is apart and failure of either of those two (hundred dollar or so) parts could cause catastrophic engine failure and cost thousands. 2.
When to replace timing belt on Acura RDX?
The timing belt system includes idler pulleys and a belt tensioner. These components should be replaced along with the belt. On some cars, the timing belt drives the engine’s water pump. Mechanics will usually recommend replacing the water pump at the same time that the timing belt is replaced.
Where can I get a timing belt replacement?
Subaru WRX STI Timing Belt Replacement at your home or office. Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing. Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.
When to replace timing belt on VW Passat?
If an engine is equipped with a timing belt, the timing belt must be replaced at the service interval specified by the vehicle manufacturer regardless of whether or not any problem is visible, typically in the range of 60,000 to 90,000 miles. Your vehicle owner’s manual should state the specific service interval.
Where are the oil plugs on a Subaru WRX?
You’ll see oil either at the bottom of the timing cover or behind right under the cam gears if they’re leaking, and yes the dealer should have those on the shelf. Those access plugs are on the front of the block with 10mm (I think) hex keys in them.
Why does my Subaru timing belt make a ticking sound?
As the timing belt begins to break down the teeth on the inside can break off and as it rotates between the camshaft and a crankshaft gear it can produce a ticking sound. The sound is not unlike a fast spinning roulette wheel in some vehicles.
Do you need a timing belt or timing chain?
Subaru vehicles function the same as vehicles made by other manufacturers in this regard. Your Subaru engine needs to have either a timing belt or a timing chain in order to synchronize all the parts in this precisely timed system. Do Subarus Have a Timing Belt or a Timing Chain?
Can a Subaru WRX leak at 130K miles?
Honestly, none of the three WRXs I’ve done recently were leaking there at 130K miles-ish, but it’s quite common on EJ25 SOHC. Dealer will have those washers on the shelf too
What’s the best way to replace a timing belt?
Compress the hydraulic belt tensioner pin. The manual says to use a vertical press, but I did it with a C-clamp. You’re supposed to do it over 3 minutes time, so take your time and compress it slowly. Once you get it down, use a 2mm allen wrench to secure the pin in place. 15.
What should the torque be on a meatys timing belt?
New pulleys will make no noise, and will not continuously spin on their own. After replacing all necessary worn idler pulleys, be sure to leave the lower left pulley off (the one we removed in step 10) Torque replaced pulleys to 39 N-m / 28.9 ft lbs.
What happens if you spin the timing belt the wrong way?
Not following the diagram, and spinning the pulleys in the wrong direction could cause interference in the valves, causing them to bend, thus creating a very expensive and timely repair! Keep your new timing belt free from any contaminants.