When should I replace my Subaru clutch?
They’re designed to last at least 50,000 miles, but it can vary based on how well you take care of your car and what your driving style is. If you do a lot of city driving, you may find that your clutch wears out faster due to the frequent shifting between lower gears.
How much does it cost to replace a clutch on a FRS?
The average cost for a Scion FR-S clutch replacement is between $981 and $1,142. Labor costs are estimated between $590 and $744 while parts are priced between $392 and $398.
How do you adjust a clutch point?
Hold a ruler parallel to the clutch cable and measure the travel of the operating lever. Measure the distance between the clutch operating lever and a point of reference such as the edge of the clutch housing . To adjust, loosen the locknut and screw the adjuster nut as appropriate.
How to do a clutch replacement on a Subaru?
Do It Yourself: Clutch Replacement. 1999 Subaru 2.5RS. 5-speed Manual Transmission. This pictoral DIY covers complete dissassembly and reassembly over the entire job (no “repeat steps in reverse” finish). Dissasembly is covered from Steps 1 to 27. Reassembly is covered from Steps 28 to 52.
How long does it take to change clutch in Subaru Impreza?
My first clutch change took 5 hours taking our time and being logical, methodical and careful. The third (last) change took 3 hours and was a snack. It gets easier with practice. Pork Hunt Motorsport – doin’ it like a porkhunt since ’07. Thats very good going!!! Autodata gives 5.1 hours to change it.
How to remove a gearbox from a Subaru Impreza?
Then, with the gearbox supported by a trolley jack, start undoing the gearbox crossmember bolts. After it has come down a short way you’ll have to undo the shifter mechanism, and then its right to slowly lower it down. This is where the extra hands are useful (to stop it falling off the jack).
How long does it take to reassemb a Subaru GC8?
Reassembly is covered from Steps 28 to 52. This task could take from 12 to 20 hours, depending on how particular you are with cleaning all your parts. A helper is needed to work the floor jack to lower and raise the transmission while you steady it under the car. It is helpfull to use the Electrical & Torque Checklists below during reassembly.