Why does my VTEC solenoid keep going bad?
The fact the solenoid continuously fails may indicate that electrical side or mechanical side behind it is not working properly. These assemblies can clog and cause issues with the solenoid. You can replace or clean the assembly if needed. If the assembly is fine, you will want to turn to electrical testing.
How to replace a solenoid gasket on a Honda VTEC?
Loosen the three 10 mm bolts that hold the valve housing to the block, and then remove them by hand and set the valve aside. Use rubber gloves to protect your skin and sandpaper or a Scotch-Brite pad to clean the gasket contact area of any backed-on oil residue or pieces of gasket. Clean it one more time with a rag.
What is part number for spool valve on VTEC solenoid?
– If you feel the need to replace the screen and gasket, it is part number 15825-P13-005 and is listed as Filter Assy., Spool Valve. I hope this helps some people out in doing some work on their own car and that people find it useful!
How to clean a VTEC solenoid with a rag?
– Remove the green connector that has the yellow arrow pointing to it, it’s the VTEC pressure switch. Squeeze and pull it straight back, then tuck it to the side. – Get your rag handy and grab your wrench and 10mm socket. There are 3 bolts that go around the solenoid, circled below.
Why is the gasket on my Honda VTEC leaking oil?
Is Your VTEC Solenoid Gasket Leaking Oil? Typically, the VTEC solenoid valve gasket is often overlooked because of the valve cover gasket right above it, which means that any oil residue may have come from the problematic valve cover gasket.
Loosen the three 10 mm bolts that hold the valve housing to the block, and then remove them by hand and set the valve aside. Use rubber gloves to protect your skin and sandpaper or a Scotch-Brite pad to clean the gasket contact area of any backed-on oil residue or pieces of gasket. Clean it one more time with a rag.
Is Your VTEC Solenoid Gasket Leaking Oil? Typically, the VTEC solenoid valve gasket is often overlooked because of the valve cover gasket right above it, which means that any oil residue may have come from the problematic valve cover gasket.
Can a gasket be replaced on a Honda K24?
Here’s how to replace a leaking or clogged VTEC solenoid and gasket on the 2.4L 4 cylinder K24 engine. Leaking a leaking VTEC gasket or clogged/malfunctioning VTEC actuator are a common problem on older Honda’s.
What to do about a Honda solenoid leak?
Just a very thin light layer and smear it flat. Leave the gasket completely clean. 1 or 2 bolts could be slightly torqued over than the other bolts, the unit lifts up at one edge and it develops a leak Not necessarily relevant, but I only trust Honda gaskets for this type of stuff because of past bad experiences with questionable aftermarket parts.