How do you reset the tpms on a 2015 Subaru Outback?
To Reset the Warning Light Perform the following two steps:
- Fill each tire to the recommended PSI/Air Pressure Levels. Do not forget the spare. Normally 32lbs in the Front tires and 30lbs in the Back.
- Drive the vehicle for 25/mph or more for a few minutes.
What are the warning lights on a Subaru Outback?
Got in car to hear out several hundred mile trip. Got about 3 miles from home. Turned on the cruise control. Within seconds several warning lights all came on simultaneously. the check engine light (steady) The traction control light on steady. The brake light flashing, and the cruise control indicator also flashing.
What’s the problem with my 2014 Subaru Outback?
Had the same problem with my 2014 Subaru 3.6R Limited. Brake light flashing, cruise control flashing and check engine light on. Checked gas cap and cleaned battery terminals did not solve the problem. Refused to go to my Subaru dealer, to be ripped off a third time I went to my local neighborhood mechanic. Problem solved!
What does DTC mean on a Subaru Outback?
When any DTC (diagnostic trouble code) is set all these lights come on to get the drivers attention. The cruise control is disabled as the vehicle now has a “fault” and Subaru engineers are not happy to have a faulty vehicle operating under cruise control.
Where are the warning lights on a Subaru Forester?
When they come on its all 3 at the exact same time. The data panel in the middle of the dash (clock panel, rear view camera panel) also displays the warnings in text mode as it cycles through them. Individually I can read and know what they might mean.
Got in car to hear out several hundred mile trip. Got about 3 miles from home. Turned on the cruise control. Within seconds several warning lights all came on simultaneously. the check engine light (steady) The traction control light on steady. The brake light flashing, and the cruise control indicator also flashing.
Had the same problem with my 2014 Subaru 3.6R Limited. Brake light flashing, cruise control flashing and check engine light on. Checked gas cap and cleaned battery terminals did not solve the problem. Refused to go to my Subaru dealer, to be ripped off a third time I went to my local neighborhood mechanic. Problem solved!
What happens to OBDII code on Subaru Outback?
If the battery is disconnected to clean the terminals, any record of that code will be erased, and if there is a fault, it could take some time for the OBD to trigger the code once again. Most national chains can read your OBDII codes (check engine light) and check battery/atlernator voltage for free.
How often do Subaru dash lights go off?
Lights used to flash for 24 hours and go off. Now it’s 48 hours on but happening every two days. I will tell my mechanic to reset the obi 4 digit codes as you have suggested.